Advertisement
Installation of Drywall Anchors
TOGGLER® brand SNAPTOGGLE® Toggle Bolt Installation Instructions
DO NOT attempt to test the snaptoggle as you will be unable to use it. Should
you need additional snaptoggles, you may purchase them at Lowes or find a
IMPORTANT! If your house is older (maybe a Victorian?) with lath board plaster ceilings and walls, DO NOT use the
new drywall anchor system. Old lath board plaster walls are not strong enough to hold drywall anchors. You must at-
tach the pot rack to wood joists with 4" wood hook/screws (included with your pot rack).
1)
Using an electric drill with ½" bit, drill a hole at each of your marked
points. Hold metal channel flat alongside plastic straps
and slide channel through hole. Minimum clearance behind ceiling
should be 1 ⅞".
NOTE: If a wood joist happens to be located at one of those points, use one of
the
4" wood screw hooks provided and screw it into the joist. (Pre-drill a hole in the
joist so the hook is easier to screw into the hole.)
We also understand--if you prefer, you can use the two wood screw hooks pro-
vided and drive them into the joists so you're confident with the strength of the
attachment. However, to do so will likely require placing a cross bar (not includ-
ed)
above the ceiling which will often necessitate a carpenter's services.
Hold ends of straps between thumb and forefinger and pull toward you until
2)
channel rests flush behind drywall. Slide plastic cap along straps with other
hand until flange of cap is flush with the ceiling
Bend straps at ceiling by pushing side to side, snapping
3)
off straps level with flange of cap.
Insert screw hook and tighten until flush, then stop.
4)
NOTE: If you are also installing Trim Ceiling Covers (a RACK IT UP accessory), see pack-
age instructions before inserting and tightening bolt/hook.
½" drywall - 265 lbs.
⅝ " drywall - 356 lbs.
Industry safety standards recommend ¼ of ultimate test load
That's' it – You are now ready to hang your new pot rack!
U.S. Patent no. 6, 161,999 and foreign counterparts thereof and of 4, 650, 386. Other patents pending. TOGGLER and SNAPTOOGLE are worldwide registered trademarks of Mechanical plastics Corp
local resource on www.toggler.com
Toggler ® Independent Lab Results
(anchor load before failure per attachment point)
TENSILE
Ceiling
.
SHEAR
½" drywall - 241 lbs.
⅝" drywall - 324 lbs.
Advertisement
