Advertisement

Quick Links

Instruction Manual
No. 7200-00 Remote One Point Thermograph
No. 7202-00 Remote Two Point Thermograph

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 7200-00 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SATO KEIRYOKI 7200-00

  • Page 1 Instruction Manual No. 7200-00 Remote One Point Thermograph No. 7202-00 Remote Two Point Thermograph...
  • Page 2 8. Fine adjustment screw for temperature 9. Pen arm 10. Sensing bulb (No. 7200-00) Note before use This product is shipped with strict inspection and proper packaging, however the indicated value may shift due to excessive shock or vibration during transportation. After unpacking, place the unit in a stable atmosphere for one hour or more and confirm that the indicated valued is within the specified accuracy by comparison with the reliable thermometer.
  • Page 3 Open the lid pulling the lever outside. Insert two batteries and close the lid. Insert batteries and close the lid. Remove chart holder. Change chart. Attach chart holder. 10. Mount recording cylinder 11. Attach cylinder holding nut. 12. Lift pen holding clip and remove it.
  • Page 4 13. Remove cap for cartridge pen by 14. Push pen lifting lever away from you turning it counterclockwise. until it stops. 15. Set time. 16. Turn carrying handle to the left and position the cover securely. 17. Turn carrying handle clockwise until 18.
  • Page 5 Precautions Changing the pen To remove the cartridge pen, hold the pen arm and pull toward the direction of the arrow. If it is hard to pull out hold, the pen arm with small pliers. Hold the pen arm near the pen. To set the pen, slide it onto the arm until it stops.
  • Page 6 To increase indicated reading, turn the fine adjustment screw counterclockwise. To lower the indicated readings, turn the fine adjustment clockwise. Fine adjustment–upper position Fine adjustment-lower position (No. 7202-00) (No. 7200-00) Lever Insert batteries ⚫ The lid is opened when the lever is pulled outside.
  • Page 7 ⚫ After inserting batteries, close the lid pushing it downward. Name of each section Battery Lever compartment LED lamp Cylinder speed switch “How to check battery condition with LED lamp” 1. LED lamp will go out if the battery power is lower than 2.2VDC±10% under normal ambient.
  • Page 8 1 pad (55 sheets) of 7-day chart, Chart holder, 2 manganese batteries Consumable No. 7200-62: 1 pad (55 sheets) of 7-day chart for No. 7200-00 No. 7200-64: 1 pad (55 sheets) of 32-day chart for No. 7200-00 No. 7202-62: 1 pad (55 sheets) of 7-day chart for No.7202-00 No.

This manual is also suitable for:

7202-00

Table of Contents