Customize Your Tv - Philips 26PFL3403/10 User Manual

6.5

Customize your TV

Set preferences
When preferences are configured, they remain
in operation until they are reconfigured.
1. Press MENU on the remote control and
select Installation
The Preferences
Preferences
Return
Program number
Language
Maximum TV volume
Power Savings Mode
Display program number permanently or not.
Tick the box: </> keys.
2. Press EXIT to close the menu.
3. Select Return and press OK to return to
the Installation
Description of preferences
•
Program number
the number of the program being watched.
To enable the function, press Í, Æ or OK
to check the box.
• : Press Í or Æ to select the
Language
menu language.
Note
D
When you select a language, it is applied to
the menus immediately.
• Maximum TV volume:
maximum volume. Press Í or Æ to set the
volume. To hear the level that you have just
set, press the OK button and hold it for a
few seconds.
• Power Savings Mode
is active the TV set automatically goes
into standby mode after ten minutes if it
EN-24
> Preferences.
menu appears.
English...
menu.
: Permanently displays
Sets the
: When this mode
does not receive any signal on the selected
program. To enable the mode, press Í, Æ or
OK to check the box.
Configure AV sockets
You can configure your TV according to the
equipment you connect to it.
1. Press MENU on the remote control and
select Installation
The Input settings menu appears.
Input settings
Return
E E XT 1 name
EXT 1 video input
EXT 2-CVBS name
EXT 3 name
EXT 2-YPbPr name
HDMI name
PC name
S elect the name of the device connecte d
Use the messages on screen and the following
instructions to configure the AV sockets.
• EXT 1 name :
If required, change the name as follows:
• Press Æ to select EXT 1_ _ _ .
• Press Î and ï to select a letter, number
or symbol.
• Press Æ to go to the next character.
• Repeat the above steps until the name
is set.
• Press OK to confirm.
• EXT 1 video input
select the type of video signal transmitted
by the equipment connected to the
EXT 1 socket. Select RGB if no picture
is displayed when you connect a games
console.
> Input settings.
EXT 1
CVBS...
EXT 2
EXT 3
EXT 2
HDMI
PC
: Press Í or Æ to