Install The Remote Control Batteries; Connect The Antenna Or Cable - Philips 32PFL5403/93 User Manual

3. Firmly pull the stand from the bottom of the
TV. Place both the stand and bolts in a secure
location for future reinstallation.
Step 3 Connect cables
Connect the antenna cable, AC power cord and all
other devices to the back of the TV as described in
the following sections and in Section 7 Connect devices.
Step 4 Secure the VESA-compatible wall
bracket to the TV
Warning
B
Only use the specified bolts (M6 x 10mm)
to secure the VESA-compatible wall
bracket to your TV. The specified bolts are
designed to match the weight of your TV.
Note
D
Depending on your VESA-compatible wall
bracket, you may need to separate the mounting
plate from the wall bracket for easier installation.
Refer to your VESA-compatible wall bracket
documentation for instructions.
200 x 300mm
EN-8
4.3 Install the remote control
1. Open the battery cover on the back of the
remote control.
2. Insert the 2 batteries supplied. Make sure the
+ and - ends of the batteries line up correctly.
(inside of case is marked).
3. Close the cover.
4.4

Connect the antenna or cable

Connect to an antenna
1. Locate the TV ANTENNA connector on the
back of the TV.
2. Connect one end of an antenna cable (not
supplied) to the TV ANTENNA connectors. Use
an adaptor if the antenna cable does not fit.
3. Connect the other end of the antenna cable to
your antenna outlet, ensuring that the cable is
tightly secured at both ends.
batteries
PC IN
VGA AUDIO IN
HDMI 1 CVI 1
HDMI 2
CVI 2
75 Ω
SPDIF OUT L-AUDIO OUT-R