General Setup Information - Sony SLV-M20HF Hook-Up Manual

General setup information

Setting the RF unit
When connecting the VCR to the TV
using only the antenna cable, you must
set the RF UNIT switch on the rear of the
VCR so that the TV can receive the
correct signal from the VCR.
1
Set the RF UNIT switch on the rear of the VCR to CH 3 or CH 4,
whichever channel is not used in your area. If both are used, set the
switch to either channel.
2
Press POWER to turn on the VCR.
3
Press TV/VIDEO to turn on the VIDEO indicator in the display
window.
4
Press CHANNEL +/– to display a channel number in the display
window. Select an active channel number in your area.
5
Turn on your TV and set it to the channel you selected in step 1
(channel 3 or 4).
The selected TV channel broadcast appears on the TV screen. If the
channels change when you press CHANNEL +/– on the VCR, you
have made the correct setting.
Whenever you use the VCR, set the TV to the channel selected in step 1.
RF UNIT
CH3 CH4
POWER CHANNEL +/–
1 2 3
4 5 6
7 8 9
0
TV
POWER
TV/VIDEO
continued
43