Sony SLV-M20HF Hook-Up Manual page 10

Step 3: Hookups (continued)
C Use this hookup if your TV has the S-Link™ function
VCR
AUDIO VIDEO
S-LINK
Audio/video cable (supplied)
Note
• To play a tape in stereo, you must use the A/V connection.
A/V hookup:
After you've connected your TV and completed antenna or cable hookup,
use the following procedure to set up the VCR.
Press MENU and select
ADVANCED OPTIONS.
MENU
TIMER SET / CHECK
TUNER PRESET
CLOCK SET
LANGUAGE
CABLE BOX CONTROL
ADVANCED OPTIONS
SMARTFILE EDIT
Use
i t e m, t h e n p u s h OK
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure
to do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the antenna terminals of your receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
10
LINE-1 IN
LINE OUT
VCR setup
t o s e l e c t a n
TV
IN
VIDEO
AUDIO OUT
AUDIO
S-LINK
Audio cable (not supplied)
Set AUTO ANT SEL to OFF and
press the cursor stick (OK).
ADVANCED OPTIONS
AUTO ANT SEL
AUTO STEREO
AUDIO MIX
/
TUNER AUDIO
SHARPNESS
DEFAULT SPEED
Use
i t e m, t h e n p u s h
For details, refer to page 34 of the
supplied operating instructions.
Stereo receiver
AUX IN
page1
ON OFF
ON OFF
ON OFF
MAIN SAP
L – – H
EP
t o s e l e c t a n