Table of Contents
Advertisement
Please note:
Depending on the system
width and the installation
situation, it may be
necessary to remove the
rollers (See page 48) or
the HQ 5 from the section
for better accessibility.
Required tools
• Hex wrench SW8
1.
Remove the motor.
2.
Remove the protective
cap from the shaft of the
new motor.
3.
Lubricate the motor
shaft.
4.
Install the new motor.
Please note:
• The end faces of the
motor and gear must be
undamaged.
• Do not tilt the motor
and make sure it has the
necessary clearance area
for installation.
• Install the motor in the
proper position (terminal
box) and connect it to the
gear.
• If the motor is not in
the proper position: do
NOT rotate the motor.
Disconnect the motor
from the gear and
reconnect it.
10.4.3
Replacing a standard motor
4
1
Fig. 23:
Replacing a standard motor
Maintenance and repair
3
gleitmo 585 K
2
3 842 558 544/2017-07, MIT: HQ 5/H, HQ 5/XH, Bosch Rexroth AG
45/60
4x
1
4
SW8
M
=20 Nm
D
557 617-23
Advertisement
Table of Contents
