Philips 43PUT6504/56 Service Manual page 27

• By using the CLEAR command in the Factory mode:
• By using the following key sequence on the remote control transmitter: "062599" directly followed by the OK button.
• If the contents of the error buffer have not changed for 50 hours, the error buffer resets automatically.
Note: If you exit SAM by disconnecting the mains from the television set, the error buffer is not reset.
5.3 Set Option Code
Press the following key sequence on a standard RC transmitter: "062598" directly followed by MENU and "xxx", where "xxx" is a 3 digit decimal value
of the panel type: see column "Set Option Code" in below tab. After resetting the Display Code, restart the set immediately.
CTN_ALT BOM#
50PUT6604/79
50PUT6604/98
55PUT6784/56 TPT550J1-QUBH84.K SD9P0AG
55PUT6784/68 TPT550J1-QUBH84.K SD9P0AF
55PUT6784/70 TPT550J1-QUBH84.K SD9P0AF
55PUT6784/98 TPT550J1-QUBH84.K SD9P0AG
Panel Type
TPT500B5-U2T01.D S01G
TPT500B5-U2T01.D S01G
Panel ID
CTN_ALT BOM#
TBD 58PUT6604/79
TBD 58PUT6604/98
TBD 65PUT6784/56
65PUT6784/75
TBD
65PUT6784/79
TBD
65PUT6784/98
TBD
Panel Type
TPT580B5-U1T01.D S01E
TPT580B5-U1T01.D S01E
TPT650J1-QUBF90.K S9WP1H
TPT650J1-QUBF90.K S9WP1H
TPT650J1-QUBF90.K S9WP1H
TPT650J1-QUBF90.K S9WP1H
Panel ID
TBD
TBD
TBD
TBD
TBD
TBD