Table of Contents
Advertisement
Adjust speaker level
•
Front Left
Front Right : FR -5 ~ FR +5
•
Subwoofer : SW-5 ~ SW +5
•
•
Center
•
Side Left
•
Side Right
» By default, the speaker level is set
to 00.
DIM
Set display brightness.
DIM HIGH, DIM MID, DIM LOW
•
» By default, the dimmer is set to
DIM MID.
DISPLAY
Set to turn off the display automatically
(except the Wi-Fi LED indicator) after 10
seconds of idle when no user operation.
ON: Set to display on
•
OFF: Set to display off
•
» By default, the display is set to
ON.
LIGHT
Audio light ring control.
AUTO : When the Dolby Atmos
•
format is detected, the audio
light ring will turn on for 10
seconds and turn off.
ON: When Dolby Atmos format is
•
detected, the halo light stays on
following the audio.
OFF: Set to Audio light ring off
•
» By default, the LIGHT is set to AUTO.
Note
•
The brightness should follow DIM setting.
22 EN
: FL -5 ~ FL +5
: CT -5 ~ CT +5
: SL -5 ~ SL +5
: SR -5 ~ SR +5
Standby
The unit automatically turns to Standby
mode after about 15 minutes if the TV or
the external unit is disconnected (or USB, BT
function bit playback pause), switched off.
STNBY IN 15M: Turn on the
•
Auto-Standby.
STNBY OFF: Turn off the Auto-
•
Standby.
» By default, the setting is set to off.
Note
•
To switch the unit off completely, remove the
mains plug from the mains socket.
•
Please turn the unit off completely to save
energy when not in use.
BT PAIR
Enter the Bluetooth pairing mode.
•
If you want to connect your
soundbar with another Bluetooth
device, you can activation the pairing
in the menu (BT PAIR) to disconnect
from current BT connected devices
and enter the Bluetooth pairing
mode.
> select "BT PAIR" > Then
» Press
(Enter) to confirm the
press
Bluetooth pairing mode.
Follow step 2-3 in "Play from
•
Bluetooth devices" above to pair
your Bluetooth device.
Tips
•
The "BT PAIR" menu will only be displayed
when the current signal source is in "BT" mode
Advertisement
Table of Contents
