Courtyard TCS46GL Assembly Instructions Manual

Courtyard TCS46GL Assembly Instructions Manual

Advertisement

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE INTENDED FOR RESIDENTIAL USE ONLY.
!
Warning: If the information in this manual is not followed exactly, a fire or explosion may
result causing property damage, personal injury, or loss of life.
• Do not store or use gasoline or other flammable vapors and liquids in the vicinity
of this or any other appliance.
• An LP-cylinder not connected for use shall not be stored in the vicinity of this or
any other appliance.
!
DANGER: If you smell gas:
1. Shut off gas to the appliance .
2. Extinguish any open flame.
3. If odor continues, keep away from the appliance and immediately call your gas
supplier or fire department.
• Installation and service must be performed by a qualified installer, service agent,
or gas supplier.
!
Warning:
Improper installation, adjustment, alteration, service, or maintenance can cause
injury or property damage. Read the installation, operating, and maintenance
instructions thoroughly before installing or servicing this equipment.
!
DANGER
Use the correct bolts as indicated. Do not tighten any of the bolts until is completely assembled.
Do not sit or stand on this table.
Keep children away during assembly. This item contains small parts which can be swallowed by children.
Do not use indoors or inside any enclosure.
Retain these assembly instructions for future reference.
Installer - Please leave these instructions with the owner.
Quote the following FQC NO. when contacting the service center.
TCS46GL
CARBON MONOXIDE HAZARD
This appliance can produce carbon monoxide
which has no odor.
Using it in an enclosed space can kill you.
Never use this appliance in an enclosed space
such as a camper, tent, car, or home.
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
PAGE 1 OF 7
!
WARNING: For Outdoor Use Only
COURTYARD CREATIONS INC.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TCS46GL and is the answer not in the manual?

Questions and answers

Ashlea Williams
May 21, 2025

Trying to get replacement

User image 682e2f0c07955
1 comments:
Mr. Anderson
May 24, 2025

To obtain a replacement for Courtyard part number TCS46GL, call the help line at 1-877-539-7436 between 9:00 AM and 4:30 PM Eastern Time, Monday through Friday. Provide the model number of the product and the part number and material code from the parts list. Do not return the item to the store, as the store does not stock parts.

This answer is automatically generated

Subscribe to Our Youtube Channel

Summary of Contents for Courtyard TCS46GL

  • Page 1 Retain these assembly instructions for future reference. Installer - Please leave these instructions with the owner. Quote the following FQC NO. when contacting the service center. SERVICE CENTER TOLL FREE NO. TEL: 1-877-539-7436 FAX: 1-877-539-7439 COURTYARD CREATIONS INC. PAGE 1 OF 7...
  • Page 2 This appliance has been tested to and complies WARNING with the ANSIZ21.97 - 2010 and CGA CR97-003. The installation must conform to local codes or in If the appliance is not in use, the gas must be turned the absence of local codes to the National Fuel off at the supply cylinder.
  • Page 3: Parts List

    PARTS LIST PART MATERIAL CODE PART Q’TY 17XA4907 COVER TCS46GL-CS01 17C33A0714001Y4 REAR FRAME BOLT M6*40 TCS46GL-CS02 17C33A0722001Y4 RIGHT FRAME BOLT M6*14 TCS46GL-CS03 17XD8303-----Y5 LEFT FRAME HANDLE 62TGS46GTQ101 17FA05040301-Y4 WASHER d6.5*D13*1.0 CROSS BRACE 17FD05040301-Y5 TCS46GW-CS05 WASHER d6.5*D13*1.0 FRONT DOOR TCS46GL-CS04 17FD05020601-Y5 TABLE TOP WASHER d6.5*D10*1.6...
  • Page 4 FIGURE 3 FIGURE 2 The tab #15 BOLT M6*14 #15 BOLT M6*14 Insert both ends of the cross brace (#4) into the bottom Fasten the tank support assembly (#7) to the front door grooves of the right and left frames (#2 and #3) from top (#5) by using bolts (#15) and washers (#17).
  • Page 5 FIGURE 6 FIGURE 7 Igniter Valve #15 BOLT M6*14 S tep 6: S tep 7: Place the tiles (#11) on to the table top (#6). Place the table top (#6) on to the frame assembly. See Figure 7. Fasten them together by using bolts (#15) and washers (#17).
  • Page 6 FIGURE 10 FIGURE 11 burner system fire shield Note: When closing the door, ensure that the distance hose between the hose and Note: Note: the burner system is The fire shield on the The lava rocks can not be more than 2 inches. burner system must be exposed over top of the exposed.
  • Page 7: Types Of Gas

    Please read the following switch usage instruction for lighting and to extinguish: Switch Usage Instruction Main Flame PILOT Step 1: Lighting : Step 2: Adjusting : To ignite, push the “T” shaped switch in and rotate When lit, let the “T” shaped switch pop up, wait 5 counterclockwise.
  • Page 8: Care Instructions

    INSTRUCTIONS FOR REMOVING THE TANK FIGURE A FIGURE B counterclockwise Note: Close the valve tightly before removing the tank. To remove the fuel supply hose from the tank, rotate counterclockwise. See Figure B. Loosen the fuel supply hose from the igniter valve. See Figure A.

Table of Contents