Start-Up Checklist - Poulan Pro PM21N550RH Operator's Manual

SETUP
IMPORTANT: Check oil level before each use. Add oil if needed. Fill to
"Full" line on dipstick.
ADD GASOLINE
Fill fuel tank to bottom of tank filler neck. DO NOT overfill. Use fresh,
clean, regular unleaded gasoline with a minimum of 87 octane.
DO NOT mix oil with gasoline. Purchase fuel in quantities that can be
used within 30 days to assure fuel freshness.
Wipe off any spilled oil or fuel. DO NOT store, spill or
use gasoline near an open flame.
Alcohol blended fuels (called gasohol or using ethanol or methanol)
can attract moisture which leads to separation and formation of acids
during storage. Acidic gas can damage the fuel system of an engine
while in storage. To avoid engine problems, the fuel system should be
emptied before storage of 30 days or longer. Empty the gas tank, start
the engine and let it run until the fuel lines and carburetor are empty.
Use fresh fuel next season. NEVER use engine or carburetor cleaner
products or permanent damage may occur.
QUICK ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY: 1/2" Wrench
HOW TO SET UP YOUR MOWER
1. UNFOLD HANDLE
IMPORTANT: Unfold handle carefully so as not to pinch or damage
control cables.
21" MODELS:
• Raise handles until lower handle section locks into place in
MOWING POSITION.
• Insert bolt through handle and bracket and secure with nut.
A 1/2" wrench will be required.
• Remove protective padding, raise upper handle section into place
on lower handle and tighten both upper knobs.
Gasoline Capacity and Type:
Oil Type (API: SG-SL)
Oil Capacity
Spark Plug
Blade Bolt Torque
IMPORTANT NOTE: Gasoline containing up to 10% ethanol (E10) is
acceptable for use in this machine. The use of ANY gasoline exceeding
10% ethanol (E10) violates Federal law and will void the product
warranty.

START-UP CHECKLIST

Before you start up your new mower, we wish to ensure that you receive
the best performance and satisfaction from this quality product.
PLEASE REVIEW THE FOLLOWING CHECKLIST:
• All assembly instructions have been completed.
• No remaining loose parts in the carton.
• The battery is properly prepared and charged (if equipped).
• Before starting to mow, make sure the area is clear of debris or
objects that may be thrown by the blades.
• Check the engine oil level before starting the machine.
• Ensure a responsible adult, other than the operator, is supervising
children in a safe location AWAY FROM THE MOWING AREA before
starting the mower.
• Be sure the Operator Presence Control (OPC) is working properly.
See Page 13.
9
Unleaded Regular
(Maximum 10% ethanol)
SAE 30 (above 32°F/0°C)
SAE 5W30 (below 32°F/0°C)
See Engine Manual for more
information.
See Engine Manual.
Std 9/16" hex = 35-40 FT.-LBS.
(47-54 Nm)
01/12/21 1 01/12/21 1