Advertisement
23.0 Indicator Status
Earphones Mode
Indicator Status
Power On
White light on 1 second
Power Off
White light quick flashes 3 times, then light off
Bluetooth pairing
Pairing status: white light flashes quickly(flashing once in 0.5 seconds)
(Mobile Phone/other device)
Connection successfully: white light on 2 seconds
Incoming call
The indicator light flashes every 2 seconds
Earbuds charging
White light on all the way until charging fully
Battery Low
white light flashes one time every 3 seconds
24.0 Warning Tone
Power On
Power On
Power Off
Power Off
Pairing status
Paiirng(Broadcast in double earphones)
Bluetooth pairing succeed
Connected(Broadcast in double earphones)
(Mobile Phone/other device)
Bluetooth lost
Disconnected
Volume Adjustment
Du
Volume Minimum
Dang
Volume Maximum
Dang
Incoming Call
Andriod system: Incoming call or Ringtone IOS system: Ringtone
09
Answer Call
Du
Hang up Call
Du
Call rejected
Call rejected
Low battery alarm
Battery low
xxx-xxxxxx
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
10
Advertisement
