Set-Up Mode - Respironics BiliChek User Instruction Manual

INSERTION AND REMOVAL OF BATTERY PACKS
•
To install the battery pack, insert the bottom of the battery pack into the bottom of the BiliChek® then rotate
battery and snap into place.
•
To remove the battery pack press the release latch at the top of the battery pack and rotate out of the
BiliChek.
BiliChek Hand-Held Unit
Before initial use, both battery packs should be fully charged. After installing one of the battery packs into the
BiliChek, insert the BiliChek into the charger base well "A" as shown in section 10.2 of this manual. The indicator
light will glow amber to indicate that the battery pack is being charged (consult the troubleshooting section of this
manual if the indicator light is flashing red or is not illuminated). Now insert the auxiliary battery pack into well "B" as
shown in section 10.2 of this manual. The BSI will glow amber to indicate that it is charging. Charge battery packs
fully until green light is displayed on the BSI (refer to section 10.2 of this manual).
WARNING: The battery pack is designed to work only with the BiliChek. Do not attempt to
use the battery pack with other products.
WARNING: Do not puncture or incinerate the battery or dispose of in a landfill. The battery
pack should be disposed of properly according to local guidelines.

11.0 SET-UP MODE

Before you use the BiliChek® for the first time, you must review or change certain factory settings. You can also use
these procedures to change any of the settings at a later time. The following is a list of features that can be customized to
your specific institution:
•
Audio On/Off
•
Measurement Units (mg/dL or µmol/L)
•
Automatic Power Off Time Interval (60 or 120 seconds)
•
Time Format (12H or 24H)
•
Time
•
Date format (MO/DA or DA/MO)
•
Date
Install and Remove
Battery Pack
13