285Z Series Quick Setup List Page Setup Procedure Steps to Perform Uncrating o Remove crate & banding. o Locate literature pack and identify contents. o Remove unit from bottom skid. o Make sure roll release rods are in DRIVE position.
Page 3
285Z Series Uncrating NOTICE When cutting crate from bottom skid, use caution around tires and mower rollers. NOTICE Do not tow rider. Towing the unit will cause transmission damage. Do not use another vehicle to push or pull this unit. Do not use this unit to push or pull another vehicle or object.
285Z Series Battery Activation & Install Battery Installation 1. Install and secure the battery in the battery compart- ment (Figure 3). Charge Battery 2. Connect the red positive battery cable (A, Figure 4) to the positive battery terminal, then cover the positive 1.
285Z Series Torque Mower Blade Hardware 1. Check to see that the blade and hardware are installed according to the diagram shown (A, Figure 5). 2. Torque the blade hardware to the noted torque (B): Note: Use a wooden block to prevent blade rotation.
285Z Series Check Fluid Levels Fill & Check Engine Oil Raising the engine cover to gain access to the engine (Figure 6, inset), use the dipstick to check the engine oil level. If necessary add engine oil. Check engine manufacturer’s owner’s manual for oil recommendations.
Page 7
285Z Series Lubrication Lubricate the unit at the following lubrication points as well as those shown in Figure 8. Grease: • front caster wheel axles • front caster spindle bosses • front axle center pivot • mower blade spindles • mower deck idler arm •...
285Z Series CHECK RIDER SAFETY Burnish PTO Clutch SYSTEM 1. Follow fueling and starting procedures as outlined in This unit is equipped with safety interlock switches. the Operator’s Manual. These safety systems are present for your safety. Do 2. Move the ground speed control levers into their...