Table of Contents
Advertisement
GETTING STARTED
REMOVING THE PACKING FROM THE CD PLAYER
Before connecting power to your audio system, the protective
packing should removed from the CD compartment.
To remove the protective packing:
•
Open the CD compartment by pressing down on the
OPEN/CLOSE area marked at the front corner of the CD
lid.
The lid will open.
•
Remove any cardboard protective packing from the CD
compartment.
•
Close the CD lid.
DAB/FM RADIO AERIAL
Before using your radio for DAB or FM reception, unwrap
and fully extend the aerial wire. You may need to adjust the
position of the aerial wire for maximum signal strength.
CONNECTING POWER
•
Check that the mains voltage marked on the rating plate
under the unit is the same as the voltage in your area.
•
Plug the AC power cord into the AC inlet
•
Plug the mains plug into the wall socket and switch the
mains power on.
SETTING THE CLOCK
Automatic clock setting:
The clock time will set automatically when a DAB station is
first tuned.
In areas where DAB reception is not available, manual clock
setting will be necessary.
To set the clock manually:
•
With the system set to Standby, press and hold the
ADJ./PROGRAM button on the remote control.
The display will show the legend '24 HOUR' with the digits 24
flashing.
NOTE: The display will not light during clock setting.
•
Press the
{ or } buttons to select 24 hour or 12 hour
mode for the clock.
CLOCK ADJ./PROGRAM button.
•
Press the
The display will show the time currently set with the hours
digits flashing.
•
Press the
{ or } buttons to set the hours digits to the
correct time.
•
Press the
CLOCK ADJ./PROGRAM button.
The display will show the time currently set with the minutes
digits flashing.
•
Press the
{ or } buttons to set the minutes digits to
the correct time.
•
Press the
CLOCK ADJ./PROGRAM button.
The clock settings will be stored.
7
STANDBY CONTROL
STANDBY CONTROL
To turn the system on:
•
Touch the
touchpad or press the /STANDBY button
on the remote control.
The display will light and the system will set to play the last
function used. If this was radio, the last station played will be
CLOCK
selected.
To turn the system off:
•
Touch the
touchpad or press the /STANDBY button
on the remote control.
The system and display light will switch off. The clock will
continue to run whilst mains power is connected.
ADJUSTING THE VOLUME
VOLUME CONTROL
To increase the volume:
•
Touch the
VOLUME
M
+ button on the remote control.
To decrease the volume:
VOLUME
•
Touch the
N
button on the remote control.
MUTE
The Mute function will set the volume to minimum.
To mute the volume:
MUTE button on the remote control to set
•
Press the
mute at any time.
MUTE button again to restore the volume to its
•
Press the
previous setting.
touchpad or press the VOLUME
touchpad or press the VOLUME -
Advertisement
Table of Contents
