Amplitude Edit - Technics sx-PR604/M Operating Instructions Manual

Part IX
FILTER ENVELOPE TOUCH & KEY FOLLOW
Specify how the filter envelope (curve) changes relative to
touch or note pitch.
1.
Use the PAGE buttons to view the 4/4 display.
• The display looks similar to the following.
2.
Use the buttons to the left of the display to
select a tone.

Amplitude Edit

Adjust the settings related to the volume of the sound.
LEVEL
1.
On the SOUND EDIT menu, select AMPLI-
TUDE.
• The display looks similar to the following.
2.
Use the buttons to the left of the display to
select a tone.
∧
3.
Use the LEVEL and
volume.
∧
4.
Use the TOUCH
amount of volume change in relation to how
hard the keyboard is played.
• At a – value, the softer the keyboard is played, the louder
the sound. At a + value, the harder the keyboard is played,
the louder the sound.
∧
5.
Use the CURVE and
type of volume curve depending on touch.
6.
Use the LEVEL KEY FOLLOW
tons to change the respective key follow set-
tings.
∧ ∨
• Use the SLOPE
and buttons to adjust the bend slope.
∧
Use the RANGE and
range by note name.
7.
Repeat steps 2 to 6 for the other tones, as
desired.
116
QQTG0665
∨
buttons to select the
∨
and buttons to set the
∨
buttons to select the
∧ ∨
and but-
∨
buttons to specify the pitch
∧
3.
Use the TOUCH and
how the respective filter envelopes change
relative to touch.
∧ ∨
• Use the TIME
and buttons to specify the time change,
∧ ∨
and the LEVEL and
relative to touch.
• At a – setting, the softer the keys are played, the greater
the change. At a + setting, the harder the keys are played,
the greater the change.
4.
Use the ENVELOPE KEY FOLLOW
buttons to modify how the respective filter en-
velopes change relative to note pitch.
• Adjust the respective slopes for attack (ATK), decay
(DCY) and release (RLS). Use the CENTER
buttons to specify the center of the bend slope by note
name.
ENVELOPE
Specify how the volume changes over time, from the time
the key is played to the time the sound dies out.
1.
Use the PAGE buttons to view the 2/3 display.
• The display looks similar to the following.
2.
Use the buttons to the left of the display to
select a tone.
3.
Adjust the settings for the volume envelope.
• Use the buttons below the display to set the corresponding
values. The envelope is created on the display as you
input the settings.
∧
• Use the SUSTAIN PEDAL
type of sustain.
LONG:
Extend the release time of the sound.
HOLD:
Maintain the key-pressed condition.
4.
Repeat steps 2 and 3 for the other tones, as
desired.
Sound Edit
∨
buttons to modify
buttons to specify the level,
∧ ∨
and
∧ ∨
and
∨
and buttons to select the