Download Print this page

Advertisement

Quick Links

Commercial Ice Maker
DBJ-45
Product Use Guide

Advertisement

loading
Need help?

Need help?

Do you have a question about the DBJ-45 and is the answer not in the manual?

Questions and answers

Frank Mendoza
April 1, 2025

Where can I find parts for my ice maker. DBJ-45 full bin sensor

1 comments:
Mr. Anderson
April 1, 2025

The document does not provide specific information about where to find a full bin sensor part for the LIFEPLUS DBJ-45 ice maker. However, it suggests contacting the seller or service at service@lifepluspro.com for support.

This answer is automatically generated

Lee
January 26, 2025

Can you use 5 gallon water jug

1 comments:
Mr. Anderson
February 10, 2025

The manual states that a variety of water jugs are applicable, but the diameter of the water jug outlet must be less than 3.2 inches. If a 5-gallon water jug meets this requirement, it can be used with the LIFEPLUS DBJ-45.

This answer is automatically generated

Marseilles American Legion Post 235
June 16, 2025

How long is the warranty?

Subscribe to Our Youtube Channel

Summary of Contents for LIFEPLUS DBJ-45

  • Page 1 Commercial Ice Maker DBJ-45 Product Use Guide...
  • Page 2 Please Note Please read this instruction carefully before use. Damage caused by improper operation is not covered by the warranty. After opening the box, please do not use it immediately. Let the ice machine stand upright for 24 hours first. This is because the ice machine has experienced a long time of shipping.
  • Page 3 TABLE OF CONTENTS SECTION 1 GENERAL INFORMATIONINSPECTION AFTER DELIVERY PAGES4-5 SECTION 2 STRUCTURE INTRODUCTION PAGES6-9 SECTION 3 PRECAUTIONS FOR SAFE OPERATION PAGES10-11 SPECIFICATION PAGE12 SECTION 4 SAFETY PRECAUTIONS & WARNING PAGE13 PARTS & ACCESSORIES PAGE14 SECTION 5 CONTROL PANEL & OPERATION METHOD PAGES15-16 PRESET DATA &...
  • Page 4 service@lifepluspro.com GENERAL INFORMATION 1. The production of this ice maker uses advanced production technology and skilled processes, as well as the strict quality inspection, guarantees the excellent performance of the ice maker. 2. The compressor of the ice maker is very strong and efficient, it makes the ice making speed of the ice machine faster.
  • Page 5 service@lifepluspro.com WARNING DIAGRAMS AND OPERATING SAFETY INSTRUCTIONS - 5 -...
  • Page 6 - 6 -...
  • Page 7 - 7 -...
  • Page 8 - 8 -...
  • Page 9 - 9 -...
  • Page 10 service@lifepluspro.com PRECAUTIONS FOR SAFE OPERATION AFTER RECEIVING THE ICE MAKER, LET THE ICE MAKER STAND UPRIGHT FOR 24 HOURS FIRST. OTHERWISE THE COMPRESSOR MAY BE DAMAGED . Please do not use it outdoors. If necessary, be sure to make the ice maker waterproof.
  • Page 11 service@lifepluspro.com Please remove the dust from the supply socket before plugging the power plug into it, to avoid fire hazard. Keep the ice maker free of obstructions and keep the ventilation open. Do not store combustion sprays, volatile or flammable substances in the ice maker. Storage of such substances may cause an explosion or fire hazard.
  • Page 12 SPECIFICATION DBJ-45 Model 120V/60Hz Rated power / frequency 2.8A Ice making current 4.3A Ice harvest current Ice cubes number / tray 1 Level Protection against electric shock Tap water / bucket water Water inlet mode 100-800KPa Tap water inlet pressure R134a / 0.26lb...
  • Page 13 service@lifepluspro.com SAFETY PRECAUTIONS 1. The voltage of this ice maker is: 120V / 60Hz. Please solve the voltage problem before installing. 2. In order to protect the compressor, do not start the ice maker again within 5 minutes after power off. 3.
  • Page 14 service@lifepluspro.com PARTS & ACCESSORIES Snap Spring Sealing Tape Water Inlet Plug Blue Buckle ICE MAKER PRODUCT USE GUIDE Commercial Ice Maker Ice Shovel Water Inlet Hose Drain Hose Instruction PRODUCT DIAGRAM Dust cover of bucket water inlet hole Door of ice bin Control panel Sealing Ring Hot air outlet...
  • Page 15 service@lifepluspro.com CONTROL PANEL LED Display FULL WATER Ice-harvest Self Clean Blue Light Power Timer OPERATION METHOD Please note that all buttons do not need to be pressed for seconds, just click. 1. Timer button: Click it, and then click the + and - buttons to preset the auto startup and shutdown time.
  • Page 16 service@lifepluspro.com 6. Blue light: Click it to light up the bule light in the ice maker. 7. Power button: Click it to turn on or turn off the ice maker. 8. Ice full indicator: When it lights up, it means that the ice machine is full of ice. Please take out the ice for use or put them in a frozen place for storage.
  • Page 17 service@lifepluspro.com DEFAULT ICE MAKING DURATION AND ADJUSTMENT RANGE You may wonder what the numbers on the LED display meant before ice making. This is the ambient temperature detected by the ice maker. In order to ensure the quality of the ice, the ice maker will preset a default ice making duration and an adjustable duration range to prevent the ice from being too thick or too thin.
  • Page 18 service@lifepluspro.com PRECAUTIONS BEFORE INSTALLATION CORRECT OPERATION When using the ice maker for the first time or using it continuously, please follow below rules! Use an independent water source for the ice maker, and check regularly to prevent low water pressure or pipe blocked. Do not store anything in the ice bin, this will make the ice machine difficult to clean or the pipes blocked.
  • Page 19 service@lifepluspro.com Installation steps of tap water inlet mode Step 1: Hook up the drain hose 2.Insert the drain hose and install the 1.Pull out the water outlet plug (Not snap spring to fix the drain hose. sewage outlet plug) Step 2: Adjust the valve and insert the water inlet hose 1.Adjust the direction of the 2.Insert the white water 3.Fix the water inlet hose...
  • Page 20 service@lifepluspro.com Installation steps of bucket water inlet mode Step 1: Hook up the drain hose 2.Insert the drain hose and install the 1.Pull out the water outlet plug (Not snap spring to fix the drain hose. sewage outlet plug) Step 2: Adjust the valve to the bucket water inlet mode 1.Adjust the valve to the direction parallel to the water pipe.
  • Page 21 service@lifepluspro.com Discharge the sewage after self-cleaning. 1. Place a container that can hold at least 0.2 gallons of water under the sewage outlet in advance 2. Pull out the sewage outlet plug slowly 3. Plug in the sewage outlet plug again NOTE: Please cut off the water source before starting to discharge the sewage, otherwise the water will flow out from the sewage outlet all the time.
  • Page 22 service@lifepluspro.com Remove the Water Inlet Hose 2.Press the white ring of the water inlet hole and 1. Remove the small blue buckle pull out the water inlet hose WARNING: CLEAN WATER ONLY Each outlet has been marked on the unit. If there is a conflict with the instruction, it may be that the workers pasted it incorrectly.
  • Page 23 service@lifepluspro.com OPERATING INSTRUCTIONS ICE-MAKING: 1. After all the water hoses are hooked up, then plug in the power supply. 2. Click On/Off button to start the machine, then compressor will start to run about 3 minutes to pre-cooling. Then click button to adjust the time of ice making to get different thickness of ice.
  • Page 24 service@lifepluspro.com HOW TO SET 24H TIMING? Auto startup timing: Do not turn on the ice maker after plugging in the power supply, click the timer button. The number on the LED screen will change from temperature to time and flash. At this time, you can click the buttons to set the automatic start-up time.
  • Page 25 TROUBLESHOOTING ERROR CODE DBJ-45 error code and troubleshoot Error Troubleshooting Display status Cause of failure code 1.The lead wire of the 1.Press the cleaning button for temperature sensor is loose 5 seconds. "E1" 2.Temperature sensor 2.Contact seller to replace it.
  • Page 26 service@lifepluspro.com 1. This state is the ice- harvest state, and the duration will vary according to the 1.The machine is ambient temperature. The "00" harvesting ice maximum time is 3.5 minutes. After the ice harvest, the machine will continue to make ice. 1.The ice bin is full of ice 1.
  • Page 27 service@lifepluspro.com FAULT SELF-DIAGNOSIS 1. Water pump-You can directly observe whether the water flows down from the ice tray. If not, the water pump may malfunction. 2. Ice making——After the ice-making last running for 10 minutes, the water in the water tank will become noticeably cold.
  • Page 28 service@lifepluspro.com FAULT SELF-DIAGNOSIS Problem Possible cause Solution Bad socket contact Change socket Ice maker The ice bin is full of ice Remove the ice cubes does not cubes start Adjust the ice full sensing The ice full sensing plate to enable reset free plate is not reset Water source is not turned Recheck water resource...
  • Page 29 service@lifepluspro.com Improper adjustment of ice Reset ice thickness thickness Install a filter on the water transparency Water quality is bad inlet pipe. of the ice cube is not Ice maker water tank or the Clean the ice maker and very good or ice tray is very dirty replace the filter ice cube...
  • Page 30 service@lifepluspro.com IF HAVE STRANGE SMELL If the ice has a strange smell or taste. And there is a disgusting or mildewy odor in the machine, follow the self-clean steps to clean the machine. SOUND DURING MACHINE OPERATION The new ice machine may have abnormal sounds. Most sounds are normal.
  • Page 31 service@lifepluspro.com CLEANING AND MAINTENANCE MAINTENANCE Please maintain the ice maker according to this manual to ensure its performance and service life. 1. Always keep the cold air inlet and hot air outlet at the lower end of the ice machine unobstructed.
  • Page 32 service@lifepluspro.com ATTENTION 1. Cleaning and maintenance of the ice maker is not included in the our free service. We suggest you use filtered water. 2. Before cleaning and maintenance, please make sure to cut off the power supply. 3. Please cut off the water source before pulling out the water inlet hose of the ice machine to prevent high-pressure water splashing.
  • Page 33 service@lifepluspro.com HOW TO STORAGE If you will not use it for a long time, please unplug it and empty the residual water in the water tank and water pipe of the ice machine. Dry the interior with a clean soft cloth (refer to maintenance and cleaning) Warning: Don't touch the power supply with wet hands! Don't pull out the machine by pulling the power code!
  • Page 34 Choose LifePlus, Choose A Plus Life. Service E-mail: service@lifepluspro.com We provide great warranty service. If you encounter any difficulties, please contact the above email for help. We will reply you within 24 hours.