Advertisement
Diagnostic Instructions
Base
Locking
Caster
.75 inch (1.9 cm)
Flat Washer
.25 inch (.64 cm)
Lock Washer
Socket Head Bolt
Hex Socket Wrench
(Allen Wrench)
Printed in USA
Mobile Stand Assembly Instructions
Model 48850
Locking Caster
Figure 1
Exam Light/Mounting Plate Instructions, see reverse.
Components
•Column (1)
•Base (1)
•Locking Casters (2)
•Non-Locking Casters (3)
•.25 inch (.64 cm) Lock Washer (1)
•.75 inch (1.9 cm) Flat Washer (1)
•Socket Head Bolt (1)
•Hex Socket Wrench (1)
•.50 inch (1.27 cm) mounting screws (2)
Caster/Base Assembly Instructions (figure 1):
Push casters into the holes of the base until they "snap"
into place. Alternate casters as shown.
Base/Column Assembly Instructions (figure 2):
1. Insert column into center hole of base.
2. Insert .25 inch (.64 cm) lock washer, .75 inch (1.9 cm)
flat washer and 1 1/4" (3.2 cm) socket head bolt into
center hole. Tighten socket head bolt with hex socket
wrench.
Column
Base
Mounting Plate
Figure 2
Part No. 488057 Rev. B
Advertisement
Table of Contents
Related Manuals for Welch Allyn 48850
Summary of Contents for Welch Allyn 48850
- Page 1 Diagnostic Instructions Mobile Stand Assembly Instructions Model 48850 Components •Column (1) •Base (1) •Locking Casters (2) •Non-Locking Casters (3) •.25 inch (.64 cm) Lock Washer (1) •.75 inch (1.9 cm) Flat Washer (1) Base •Socket Head Bolt (1) •Hex Socket Wrench (1) •.50 inch (1.27 cm) mounting screws (2)
- Page 2 Insert the .50 inch (1.27 cm) screws through the bottom of the mounting plate and tighten with a phillips head screw driver (not included). Exam Light Keyhole Pin in slot. Figure 3 .50 inch (1.27 cm) mounting screw Welch Allyn, Inc. 4341 State Street Road PO Box 220 Skaneateles Falls, New York 13153-2002 USA Telephone: (315) 685-4560 Fax: (315) 685-3361...
Need help?
Do you have a question about the 48850 and is the answer not in the manual?
Questions and answers