C1Gr, C2Gr; Cc26R - Grant C1GR Operating Manual

2.2.1

C1GR, C2GR

The C1GR and C2GR are designed for use with the Grant ST Series baths. The C2GR is only suitable for
fitting in the 26, 28 and 38 litre baths.
For fitting immersion coil in the ST series baths:
1. Remove bridge plate from ST bath. Remove the black
rivets to separate the blanking plate. Retain the rivets
for later
2. Use the thumb screws provided to secure the "u"
shaped bracket to the blanking plate as shown.
Slide the cooling coil over the "u" shaped bracket and
3.
feed the cooling coil through the bridge plate. Check
that the coil hose fits through the cut out.
4. Secure the blanking plate with the rivets.
Ensure that the unit is located so that the ventilation grilles
are not less than 100mm from any obstruction.
The cooling coil may be immersed in liquids up to 100°C but
the cooler should only be used to cool down the liquid, not to
operate continuously above 40°C.
Immersed material: the cooling coil is nickel plated copper.
2.2.1

CC26R

The CC26R is designed for use with the Grant OLS26 shaking water baths.
For fitting immersion coil into the OLS26 shaking water bath:
1. Remove shaking tray and trolley from the OLS26
2. Position the CC26R cooling unit next to the OLS26. Ensure that the ventilation grilles are more than
100mm from any obstruction
3. Place the immersion coil in the base of the bath with
the feed pipe at the rear. Hold in place with the
retaining plate
4. Slide the locking plate onto the bath's cam block
housing and fasten with the 2 thumbscrews
5. Refit the shaking trolley and tray
Grant recommends a 50% water and Ethylene glycol
(antifreeze) solution. Please follow the instruction included
with the OLS26 shaking water bath regarding filling the unit,
setting operating temperature and shaking speed.
The cooling coil may be immersed in liquids up to 100°C but
the cooler should only be used to cool down the liquid, not to
operate continuously above 40°C.
Immersed material: the cooling coil is nickel plated copper
C1GR, C1GR US, C2GR, C2GR US, CC26R, CC26R US
Operating manual Part No. 34960
www.grantinstruments.com
Page 6