Safety - Grant C1GR Operating Manual

1

Safety

The following symbols marked on the equipment mean:-
Caution: Read these operating instructions fully before use and pay particular
attention to sections containing this symbol
Warning; flammable material
Always observe the following safety precautions
•
Use only as specified by the operating instructions: if the equipment is used in a manner not
specified by the manufacturer, the protection provided by the equipment may be impaired.
•
Consult the user manual for the equipment with which you intend to use this accessory
cooler: ensure that you know how to operate it safely and are aware of any hazards,
particularly relating to very hot or cold surfaces, or fluids and whether any of the fluids are
hazardous.
•
After transport or storage in humid conditions, always allow the equipment to stand for at
least an hour at room temperature before operating.
•
Connect only to an ac power (mains) outlet with a voltage corresponding to that on the serial
number label.
•
This product must be connected to an earthed ac power (mains) outlet.
•
Before moving, disconnect from the ac power (mains) supply.
•
When lifting use top flange by the ventilation grilles at the front and rear or lift from under the
base.
•
Only use the mains cord provided or one with an identical rating. Ensure that the ac power
(mains) plug and the switch are easily accessible during use.
•
Do not block or restrict the ventilation slots.
•
If liquid is spilt inside the unit, disconnect it from the power supply and have it checked by a
competent person
•
It is the user organisation's responsibility to carry out appropriate decontamination if
hazardous material is spilt on or inside the equipment
When using with Baths
•
Do not check the temperature by touch, use the temperature display or a thermometer.
•
To reduce the risk of eye injury during high temperature operation, use safety goggles or
spectacles.
•
Heat transfer fluids may be hazardous, make sure the Material Safety Data Sheet (MSDS)
for the heat transfer fluid is available and the appropriate protective equipment is used.
C1GR, C1GR US, C2GR, C2GR US, CC26R, CC26R US
Operating manual Part No. 34960
www.grantinstruments.com
Page 4