Advertisement
Quick Links
The Video Switch set contains:
1 Video Switch Unit
4 Rubber Feet
1 HD Camera cable (1 m) for 6000MXP Codec
1 HD Camera cable (1 m) for 3000MXP Codec
1 Power supply kit incl. cables for Video Switch
1 Power supply kit incl. cables for existing camera
1 Rack ear set (left and right)
1 Control cable (6.5 m) for Video Switch to Precision HD camera
1 HDMI cable (6.5 m) for Video Switch to precision HD camera
1 TRC4 TANDBERG Remote Control
Please report any discrepancies immediately.
3
Connecting up to four
TANDBERG Precision
HD cameras:
Connect TANDBERG Video Switch
power supply here.
Connect camera power supply
here.
The Codec must be equipped with
software version F6.1 or higher to
support the use of the Video Switch.
Page 1 of 6
Connecting the Video Switch
1
Unpack the unit.
TANDBERG Video Switch
TANDBERG 6000 MXP Codec
2
Mount the rack ears
and/or rubber feet
and mount it in the
rack, if applicable.
Camera 2
DVI – HDMI
DVI – HDMI
I
O
DC in
DB 9 – RJ 45
Camera 3
RJ 45 – DB 9
DVI – HDMI
Video in
PC DVI-I in
Audio in
2. Aux
3. Doc
4. VCR
PC Card
3
4
1
2
Data
Video out
DVI-I out
VCR
1
2
1. Single
2. Single
3. Dual
Mic.1
Mic.2
USB
USB
Audio out
TANDBERG 3000 MXP Codec
Put the Video Switch power
supply here when rack
mounting.
Rubber feet
(rubber pads)
Camera 4
Ethernet
Camera
Net
116467.05
Advertisement
Related Manuals for TANDBERG RJ45RJ11
Summary of Contents for TANDBERG RJ45RJ11
- Page 1 1 Rack ear set (left and right) 1 Control cable (6.5 m) for Video Switch to Precision HD camera 1 HDMI cable (6.5 m) for Video Switch to precision HD camera 1 TRC4 TANDBERG Remote Control Please report any discrepancies immediately. Connecting up to four...
- Page 2 This diagram shows the additional connections needed to expand from using up to four TANDBERG Precision HD cameras (see overleaf) to also include up to three TANDBERG WAVE II cameras (i.e. up to seven cameras in total). Connect Video Switch power supply as shown overleaf.
-
Page 3: Basic Functionality
Installation of the Video Switch Basic Functionality Physical inputs refer to explicit codec input and explicit switch input. These can only be controlled from the command interface. xconfiguration MainVideoSource, vidin and xconfiguration Switch Source always control the inputs directly. Example: To select physical input 3 on the codec, use xconfiguration MainVideoSource: 3, as usual. -
Page 4: Communicating With The Video Switch
Since the switch has two possible camera chains, implementation, refer to the System Integrators all normally formatted commands will be sent to Guide – Interfacing to the TANDBERG Wave 2 the primary chain. To access the secondary chain, Camera. you must first turn Enhanced VISCA on with the SW_eVisca command. -
Page 5: Configuration Commands
Command Packet SW_Input_Set 8x 01 40 20 0p ff Misc. Command Command Packet CAM_Boot 8x 01 42 ff www.tandberg.com Page 5 of 6 Inquiries Messages starting with 8x- 09... Comments Command set Currently not in use. CAM_ID_Inq Currently not in use. -
Page 6: Communication Lines
No license is granted under any patents or patent rights of TANDBERG. For your protection please read these safety instructions completely before you con- nect the equipment to the power source.