Advertisement
using the sprocket Holding tool, make any final adjustment
required to the camshaft position so the lobe aligns with the
setting Plates (fig.19).
Whilst maintaining this position with the Holding tool,
CHECK THAT THE BASE OF THE SUPPORT BLOCK
RESTS ON THE SURFACE OF THE CYLINDER HEAD AND
THAT THE SETTING PLATES ARE ALIGNED WITH THE
PROFILE OF THE CAMSHAFT LOBES, and insert the four
flanged securing Bolts. tighten evenly to 10nm.
repeat the same procedure with the Exhaust setting Plate
Assembly/camshaft.When fitting the new timing belt the
camshaft sprockets must be 'free to turn' on the camshaft and
therefore it is necessary to slacken the camshaft sprocket bolts.
WARNING: DO NOT use Al-Fi Camshaft Setting Plate
Assemblies to counter-hold camshafts in position whilst
releasing or tightening the sprocket bolts as this will damage
the Setting Plates. Al-Fi Assemblies are for retention of
timing position only. A suitable Sprocket Holding Tool MUST
BE used to counter-hold the sprockets.
When fitting the new timing belt the camshaft sprockets must be
'free to turn' on the camshafts and therefore it is necessary to
slacken the camshaft sprocket bolts.
5.8
Crankshaft Pulley Removal.
VS1403/03 Flywheel Holding Tool (Crank Pulley removal) -
Associated Tool - not in kit.
the crankshaft pulley must be removed in order to replace the
timing belt.
on 2.0 engines a centre bolt retains the crankshaft pulley and it
will be necessary to firmly and safely 'lock' the flywheel when
releasing and tightening the pulley bolt. flywheel Holding tool
VS1403/03 can be used to 'lock' the flywheel on this application.
Extend Your AL-Fi Application Coverage.
AL-fi setting Plate sets for fiat 1.8 16v. and 2.0/2.4 20v. twin
cam petrol engines are available to use with the support blocks in
this kit, to cover these fiat applications.
VS4902 for 1.8 16v. Punto, Brava/Bravo, Marea/Weekend,
Barchetta, coupe & stilo (183A1.000, 182A2.000, 188A6.000 &
192A4.000).
VS4903 for 2.0/2.4 20v. Bravo, coupe & stilo (182A1.000,
182B7.000, 192A2.000, 182B3.000 & 175A3.000).
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey Limited
Environmental Protection
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park,
Bury st. Edmunds, suffolk,
IP32 7Ar
Original Language Version
Fig.19
01284 757500
01284 703534
www.sealey.co.uk
sales@sealey.co.uk
Vs4910
Issue:3 (sP) - 08/07/15
Advertisement
