Table of Contents
Advertisement
■ LCD panel
・ Do not drop or have a strong impact on the programmable display unit as glass is used for the LCD
panel.
・ The liquid in the LCD panel is a hazardous substance. If the LCD panel is broken, do not put the
leaked crystalline liquid into your mouse. Should it get into your mouse, immediately gargle, and
consult a doctor. If it adheres to your skin or clothes, wash it away with soap.
・ On the LCD panel, bright spots ( points always lit) or black spots (points always unlit) may appear, or
the uneven brightness, flickers or crosstalk (appearance of unintended shades in the area no graphic
or part is arranged) may occur depending on the operating conditions.
・ Note that these phenomena are resulted from the basic characteristics of LCD panel not defects or
failures of the product.
・ The equipment must be cleaned only with a soft cloth. Do not use solvents.
■ Scratch protection sheet
・ A sheet is affixed to the touch panel to protect it from scratches when shipping. Please remove it
before using the HMI.
■ Cautions on handling a USB memory
・ Do not remove the USB memory while the power is on.*
*Communication may be stopped. It is necessary to restart the power supply to recover.
・ The data saved in the USB memory may be lost in the following cases. We assume no responsibility
whatsoever for the lost of saved data.
When a user or third party used the USB memory incorrectly.
(1)
When the USB memory was affected by any static electricity or electrical noise.
(2)
(3)
When the USB memory was removed or the power supply of the HMI unit was turned off while data
was being read, written or deleted to/from the USB memory.
・ It is recommended to save important data in another media for backup.
■ Cautions on handling a SD memory card
・ Do not remove the SD memory card while the power is on.*
*Communication may be stopped. It is necessary to restart the power supply to recover.
・ The data saved in the SD memory card may be lost in the following cases. We assume no
responsibility whatsoever for the lost of saved data.
When a user or third party used the SD memory card incorrectly.
(1)
When the SD memory card was affected by any static electricity or electrical noise.
(2)
When the SD memory card was removed or the power supply of the HMI unit was turned off while
(3)
data was being read, written or deleted to/from the SD memory card.
・ It is recommended to save important data in another media for backup.
PROGRAMMABLE DISPLAY WHA1 Advanced Model
Advertisement
Table of Contents
