Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Sur-Gard SG SECURITY PC-LC2
Summary of Contents for Sur-Gard SG SECURITY PC-LC2
- Page 1 PC-LC2 Installation Manual Version 1.0 firealarmresources.com...
-
Page 2: Industry Canada Notice
Industry Canada NOTICE Notice: Notice: Notice: Notice: The Industry Canada label identifies certified equipment. This Notice: de protection, d'exploitation et de sécurité des réseaux de certification means that the equipment meets certain telecommunications télécommunications. Industrie Canada n'assure toutefois pas que le matériel network protective, operational and safety requirements. - Page 3 TABLE OF CONTENTS Option 4C: Channel Status ..........5 INTRODUCTION Option 4D: Equivalent Line ..........5 PC Requirements ..............1 Power and Supervision ............1 PC-LC2 SYSTEM STATUS Compatibility ............... 1 PC-LC2 Stand-by Mode ............7 System Overview ..............1 1.
- Page 4 Personnel Monitoring ............11 Miscellaneous ..............11 PC-LC2 COM Status Report Messages ......... 11 APPENDIX A: PC-LC2 COMMUNICATION FORMATS APPENDIX B: DECIMAL - HEX - BINARY CONVERSION CHART APPENDIX C: PC-LC2 PROGRAMMED NUMBER CHANNEL "A" NUMBER-CHANNEL "B" NUMBER CONVERSION CHART LIMITED WARRANTY / CE CONFORMITY LAST PAGE firealarmresources.com...
- Page 5 INTRODUCTION "Apparaten skall anslutas till jordat uttag nar den ansluts The PC-LC2 is a two line multi-format digital receiver for till ett matverk." PC computers that fits in an ISA type slot of any IBM compatible computer. The PC-LC2 includes many fea- 6.
-
Page 6: Quick Start
Receives all Communication formats, except: 3/2, • SG-PC-LC2 features multiprocessor with 16-bit micro- controller 4/1 express, 4/1 extended, 4/2 extended and 4/2 • 1 parallel printer port checksum. • Programmable system functions: serial and printer, serial The above formats can be manually selected. only, serial with printer as stand-by, and printer only The signals are then sent to the parallel printer and •... - Page 7 PC-LC2 DIGITAL LINE RECEIVER PC-LC2 OPERATING MODE GENERAL INFORMATION PC-LC2 COLD START UP (COLD BOOT) The PC-LC2 16-bit microcontrollers running at 16MHz When the PC-LC2 software is upgraded, a cold boot will have to be performed to install the default system allow the system to quickly and efficiently execute software.
-
Page 8: Option 08: Caller Identification
EXAMPLE: When option 08 is selected as 2, it will send OPTION 00-07: SYSTEM HANDSHAKES the telephone number to the computer in the following The PC-LC2 has the capability to send several protocol: handshakes to the dialer. Often it is important to select which handshake is sent first. - Page 9 Sur-Gard Format (default setting) L01-1234-05 21:24-28/02/94 Sur-Gard Format with common event code (The event code sent to the computer will always be "A") The signal sent to the computer will always be followed OPTION 14: ALARM MESSAGES PRINT YEAR OR SEC.
- Page 10 A has no effect. with the Sur-Gard DTMF 4-3 with checksum format. To prevent conflicts, enable option 17 by programming “1”. Enabling this option will bypass the Sur-gard 4-3 OPTION 49: HANDSHAKE AND KISSOFF DURATION with checksum format decoding. Some control panels have difficulty in decoding the receiver’s handshake and/or kissoff tones on noisy phone...
- Page 11 PC-LC2 SYSTEM STATUS FAULT CALL PC-LC2 STAND-BY MODE The following messages are sent to the printer and When this problem is encountered, the following computer when the receiver is powered up: information is transmitted to the printer and the computer: Printer: SG-PC-LC2 MAY-14-00 V1.00 Printer:...
- Page 12 SG DTMF FORMATS Printer: TRBL ????-30 Line Restr Sur-Gard DTMF 4-3 and 4-3 with Checksum formats Computer: 0000 R 30 provide fast, reliable and easy to understand and decode data transmission. On-line time will be greatly 3. PRINTER ERROR reduced when using 4-3 and 4-3 with Checksum formats.
- Page 13 SG-PC-LC2 LIBRARY DECODING AND EVENT CODES TABLE 4-3 ALARM LIBRARY 3-1 / 4-1 ALARM LIBRARY For Alarm Corresponding Event For Alarm Corresponding Event Message Code Code (Options 19-28) Message Code Code (Options 39-48) 24HrsTest 0 (A) Fire Default Other * Panic 24HrTZn# 0xx (Axx) T...
- Page 14 CONTACT ID EVENT LIBRARY EVENT CODE CLASSIFICATIONS The event codes have been grouped according to the type of event, as described below. EVENT CODE CLASSIFICATIONS The Event codes have been grouped according to the type of event, as described below. Medical Alarms - 100 Protection loop short Medical...
- Page 15 EVENT CODE CLASSIFICATIONS CONT'D... O/C by Exception Notification Appliance ckt.#4 disable OFF Normal Condition Early O/C System peripheral Disables - 530 and 540 Video Transmitter Active Late O/C Fire Test: Point tested Module added Fail to O/C Fire Test: Point not tested Module removed Auto Arm Fail Intrusion zone walk tested...
- Page 16 2300Hz FSK MARK 110/300 tonal/ FSK MARK/ Level 1, 2 SPACE Data ack Contact ID Dual Tone DTMF DTMF 4-2-1-3-2-3 1400Hz 1400Hz Sur-Gard 2300Hz DTMF DTMF 2300Hz Sur-Gard Dual Tone DTMF DTMF 1400Hz 1400Hz Sur-Gard 2300Hz DTMF DTMF 4-3 + checksum...
- Page 17 APPENDIX B: DECIMAL - HEX - Binary Conversion Chart BINARY BINARY BINARY BINARY 0000 0000 1000 0000 1100 0000 0100 0000 0000 0001 1000 0001 1100 0001 0100 0001 0000 0010 1000 0010 1100 0010 0100 0010 0000 0011 1000 0011 1100 0011 0100 0011 1000 0100...
- Page 18 APPENDIX C: PC-LC2 Programmed Number Channel "A" Number - Channel "B" Number Conversion Chart Settings for the rotary switch and its equivalent line card number settings. Settings for the rotary switch for cold boot function... Cold boot channel A only Cold boot channel B only Cold boot both channel A and B firealarmresources.com...
-
Page 19: Limited Warranty
Technical Support If you have questions or problems when using Sur-Gard products, you can call technical support. If you are within the United States, Puerto Rico, the U.S. Virgin Islands or Canada, you can get support by dialing 1-800-503-5869 ext.1. If you are outside these areas, please call (416) 665-4494 ext.1, or e-mail us at support@sur-gard.com. - Page 20 © 2000 SG Security Communications A Division of Sur-Gard Security Systems Ltd. 401 Magnetic Drive, Units 24-28 Downsview, Ontario Canada M3J 3H9 Tel: (416) 665-4494 Fax: (416) 665-4222 The Reporter Specific Toll Free: 1-877-704-7078 29004871 R001 www.sur-gard.com Printed in Canada...
Need help?
Do you have a question about the SG SECURITY PC-LC2 and is the answer not in the manual?
Questions and answers