Input/Output Specification; Input Signal Connector - Dell W2607C Service Manual

3. Input/Output Specification

3.1 Input Signal connector

This procedure gives you instructions for installing and using the LCD TV display.
Position the display on the desired operation and plug the power cord into a convenient AC outlet. Three-wire power
cord must be shielded and is provided as a safety precaution as it connects the chassis and cabinet to the electrical
conduct ground. If the AC outlet in your location does not have provisions for the grounded type plug, the installer
should attach the proper adapter to ensure a safe ground potential.
Connect the 15-pin D-SUB or 24-pin DVI color display shielded signal cable to your signal system device and lock
both screws on the connector to ensure firm grounding. The connector information is as follow:
PIN NO.
1
2
3
4
5
6
7
8
Apply power to the display by turning the power switch to the "ON" position and allow about ten seconds for Panel
warm-up. The Power-On indicator lights "GREEN" when the display is on.
With proper signals feed to the display, a pattern or data should appear on the screen, adjust the brightness and
contrast to the most pleasing display, or press auto-adjust to get the best picture-quality.
This TV (with PC function) has power saving function following the VESA DPMS. Be sure to connect the signal
cable to the PC.
If your TV requires service, it must be returned with the power cord.
1
6
11
15 - Pin Color Display Signal Cable
Description
Red Video
Green Video
Blue Video
Not Used
Ground
Red Ground
Green Ground
Blue Ground
5
10
15
PIN NO.
9
10
11
12 Serial Data for DDC
13
14
15 Serial Clock for DDC
23
Dell W2607C
Description
No Pin!
Sync Ground
Not Used
H-Sync.
V-Sync.