Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Assemble the Castor wheels before operating the heater.
WARNING: Do not operate without wheels attached. Do operate the heater only in upright position
(feet on the bottom, controls on the top), any other position could create a hazardous situation.
1
2
3
4
2
3
.
Place the radiator body upside-down on a scratch-free location, make sure
it is stable and will not fall.
.
Screw off the wing nuts from the U-shaped bolt provided, attach the
U shaped bolt to the U-facing flange between first and second fins
(near the front cover).
.
To attach the castor mounting plate to the radiator body, you should insert
the threaded ends of the U bolt in the holes on the castor mounting plate.
. Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Note: do not over tighten, which may cause the damage of radiator flange.
4
.
Repeat , , and on the rear of radiator
for mounting of the rear Castors.
Note: the rear castors must be mounted
between the end two fins.
5
Advertisement
Table of Contents
