Canon CXDI-31 Service Manual page 147

2) Connection with the Kodak MLP-190
As a general guide for printer connections, this section describes the procedure for
directly connecting the Kodak laser printer MLP-190 to the CXDI, and then printing
out the loaded image.
See the MLP-190 Operation Manual for the specific operating procedures for the
Kodak MLP-190 (such as the mode settings, calibration, and printout procedures).
1. Required equipment
a. Hub
b. Ethernet cables (straight): 2
c. Kodak DICOM printer MLP-190
2. Connection
Use Ethernet cables (straight) to connect the CXDI to the MLP-190 by passing through
the hub as shown in the figure below.
3. MLP-190 settings
(1) Setting the IP addresses and ports
Make the settings for the MLP-190 IP addresses and ports as shown below.
(2) DICOM port: 5040 (fixed)
Refer to the CXDI Series Operation Manual ("Customizing the Image Output Settings" to
make the printer and storage settings.
2 Installation Manual
Example: 172. 17. 9. 101
- 121 -