PR XR230 BEAM Manual page 11

1- Current DMX address in large font
2- Customer's logo
3- FPS of DMX signal
4- Current DMX channel mode and the numbers mean the number of DMX channels
5- Fan speeds( it will appear or not based on actual product)
6- Current mode( Master/slave)
7- Current running mode(DMX512,auto,user)
8- Error info. If any info in red with "X", there are errors found during self test(push DOWN key for more details)
9- Temperature or other info( actual info based on actual product)
10- SN (lock and deadline status)
STAND-ALONE MODE
●
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within 512.
●MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture's DMX output to the second fixture's DMX input using XLR-XLR control cable and then connect the second
fixture's DMX output to the third fixture's DMX input, and so on until all projector are connected in this way. Eventually connect the last
fixture's DMX output to a DMX terminator. Set 1
maximum quantity of projectors in a DMX chain is less than 32.
Start Addresses of all Slaves are 001; Operation mode of the Master can be set any mode for a Master' and Slaves' operation mode can be
set accordingly.
After Powered on, the group will run in Master/Slave Mode
st projector as the master and others are Slaves. It's advised that the
11