Table of Contents
Advertisement
All manuals and user guides at all-guides.com
TROUBLESHOOTING
CD Player Operation
"NO DISC" is displayed.
• The disc is inserted upside down.
™ Place disc with printed side up.
• Moisture condensation at the lens.
™ Wait until lens has adjusted to normal
room temperature.
• There is no disc in the CD tray.
™ Insert a disc.
• The disc is dirty, badly scratched or
warped.
™ Clean or replace the disc.
• The disc lens is dirty or dusty.
™ See section under Maintenance (page
41).
"DISC NOT FINALIZED" is
displayed.
• The CD-RW or CD-R disc is not
properly recorded for use with a
standard CD player.
™ Read the instruction booklet of your
CD-Rewritable or CD-Recorder on how
to finalize a recording.
• The CD is badly scratched or dirty.
™ Replace or clean CD.
42
pg 01-43/D5/37-Eng
42
Reversed left and right sound.
Radio Reception
• Speakers are connected wrongly.
Poor radio reception.
™ Check the speaker connections and
• The signal is too weak.
location.
™ Adjust the antenna.
Lack of bass sound or apparently
™ Connect an external antenna for
imprecise physical location of
better reception.
musical instruments.
• The TV or VCR is too close to the
• Speakers are connected wrongly.
stereo system.
™ Check the speaker connection for
™ Separate the stereo system from the
proper phasing, colored/black wires to
TV or VCR.
colored/black terminals.
General
Remote control has no effect on
the system.
System does not react when any
• Wrong source is selected.
button is pressed.
™ Select the source (CD, TUNER, etc.)
• Electrostatic discharge
before pressing the function button
™ Press STANDBY ON to switch the
( É , í , ë , etc.).
system off. Remove the AC power plug
• The distance to the system is too
from the wall outlet, then reconnect
large.
the power plug and switch on the
™ Reduce the distance.
system again.
• Batteries are inserted incorrectly.
No or poor sound.
™ Insert the batteries with their polarities
(+/– signs) as indicated.
• Volume is not turned up.
™ Adjust VOLUME.
• Batteries are exhausted.
™ Replace the batteries.
• The headphones are connected.
™ Disconnect the headphones.
Timer is not working.
• Speakers are not connected or are
• Clock is not set.
connected wrongly.
™ Set the clock.
™ Check that the speakers are
• Timer is not switched on.
connected correctly.
™ Press TIMER to switch on the timer.
™ Make sure the stripped speaker wire is
clamped.
Clock setting is erased.
• There was a power failure.
™ Reset the clock.
System displays features
automatically; buttons flash
continuously.
• Demonstration mode is switched
on.
™ Press and hold Ç (on the system) for
five seconds to switch off the
demonstration.
There is a howling sound at the
external source.
• You hear feedback when you are
listening in AUX mode
™ Press AUX to select CDR mode.
All lighted buttons are not lit.
• Display is switch on in DIM 3 mode.
™ Press DIM until DIM OFF display
mode is shown.
3139 116 19774
7/13/00, 11:52 AM
Advertisement
Table of Contents
