Advertisement
NOTE: If unsure of requirements for specific application of Tie Down, seek professional advice.
4.1.
INSTALLING THE TYRE RESTRAINT
4.1.1.
Pass the section of the non-ratchet webbing into one end of the cross strap and then back through it at the other end (see fig.1)
4.1.2.
Fix the hook end of the webbing to the trailer where required (see fig.1)
4.1.3.
Loop the webbing that has been fed through the cross strap over the tyre (see fig.1).
4.1.4.
Place the webbing at approximately the 2 o'clock and 10 o'clock locations on the tyre.
4.2.
INSTALLING THE WEBBING TO THE RATCHET
4.2.1.
Pull the release lever (fig.2) to free the ratchet lever.
4.2.2.
Open the lever fully to expose the slot in the ratchet spool. It will lock in this position.
4.2.3.
Pass webbing through the slot in the ratchet and pull the webbing through to remove as much slack as possible before ratcheting.
4.2.4.
Pull the release lever to enable the ratchet lever to return to the 'down' position.
4.2.5.
Start ratcheting by raising and lowering the handle.
4.3.
RELEASING THE STRAP
4.3.1.
Pull the spring loaded release tab (fig.2) to override the ratchet mechanism.
4.3.2.
Open ratchet until it is fully open and flat.
4.3.3.
Pull webbing from the non-fixed side to remove it.
4.3.4.
Close ratchet handle once webbing removed.
NOTE: For additional information see the Sealey YouTube channel.
5. MAINTENANCE
5.1.
After use, thoroughly wipe down the strap and the ratchet body using a soft,clean and dry cloth.
5.2.
Store the unit in a clean and dry environment.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
TDRWA, TDRWKIT, TDRWS Issue 1 19/11/21
Advertisement
