Table of Contents
Advertisement
Safety Warnings
DANGER
WARNING
CAUTION
Cole Parmer
Section 1
Make sure you read and understand all instructions and safety precautions
listed in this manual before installing or operating your chiller. If you have
any questions concerning the operation of your chiller or the information
in this manual, please contact us. See inside cover for contact information.
DANGER indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It is also be used to alert
against unsafe practices.
The lightning flash with arrow symbol, within an equilateral triangle, is
intended to alert the user to the presence of non-insulated "dangerous
voltage" within the chiller's enclosure. The voltage magnitude is significant
enough to constitute a risk of electrical shock.
This label indicates read the manual.
NOTE The chiller's equipment design incorporates a complete sheet metal
enclosure for personnel protection from mechanical and electrical hazards.
Observe all warning labels.
Never remove warning labels.
The chiller construction provides protection against the risk
of electrical shock by grounding appropriate metal parts. The
protection will not function unless the power cord is connected to a
properly grounded outlet. It is the user's responsibility to assure a
proper ground connection is provided.
The circuit protector located on the rear of the chiller is not intended
to act as a disconnecting means.
If the chiller's power cord is used as the disconnecting device, it
must be easily accessible at all times.
Never operate the chiller with damaged cords.
Never place the chiller in a location or atmosphere where excessive
heat, moisture, or corrosive materials are present.
Safety
Polystat
1-1
Advertisement
Table of Contents
Need help?
Do you have a question about the Polystat I and is the answer not in the manual?