Commissioning
Preparation
•
First inspect the device visually. If you detect any damages (e.g., a damaged cable, hook, etc.),
the hand wire winch must not be used.
•
Put on suitable protective equipment, e.g., gloves.
Pulling/tensioning
Hinge the spiral spring between the hooks of the handle and the loop of the impulse click. The cable is
winded up by tilting the handle.
Untightening the cable
Remove the spring installed between the handle and impulse click. Tilt the handle to the stop of the side
where the second hook is mounted. The impulse click will be untightened, the cable drum unblocked.
While holding the impulse click, the cable can be unrolled by hand.
Main components
№
Name
1
Hook with safety bow
2
Cable drum with locking wheel
3
Triggering hook
4
Triggering spring
5
Lever
6
Cable
Important Note: Reproduction and any commercial use (of parts) of this operating manual, requires a
written permission of WilTec Wildanger Technik GmbH.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
№ Name
2
Detail cable drum
3
Detail hook
4
Detail spring
Item 30216
Page 4
01 2022-1