Advertisement
Quick Links
Penetrator X3
Fall Protection Cart
Part ID: 72810
Penetrator X3
Rescue Winch Accessory
(Purchased Separately)
Part ID: 72819
Serious injury or death may occur if this equipment is used for purposes other than intended.
Tie Down Engineering provides the following instructions for the use and care of this
equipment. It is the responsibility of the user to understand and convey proper instruction to
any and all individuals who use this product for Fall Arrest and or Fall Restraint. The
Penetrator X3 complies with the requirements set forth by the Federal Occupational Safety
WARNING: This product can expose you to chemicals including Nickel, which is known to the
State of California to cause cancer. For more information go to: www.P65Warnings.ca.gov
and Health Administration (OSHA) when used according to the manufacturers' instructions.
WARNING: This product can expose you to chemicals including Nickel, which is known to the
State of California to cause cancer. For more information go to: www.P65Warnings.ca.gov
WARNING: This product can expose you to
chemicals including Nickel, which is known to
the State of California to cause cancer. For more
information go to: www.P65Warnings.ca.gov
WARNING: This product can expose you
to chemicals including Nickel, which is
known to the State of California to
cause cancer. For more information
go to: www.P65Warnings.ca.gov
WARNING: This product can expose you
to chemicals including Nickel, which is
known to the State of California to
cause cancer. For more information
Instruction #08383 (E1847 - Rev. 9/24/21)
404-344-0000 • www.tiedown.com
605 Stonehill Drive SW, Atlanta, GA 30336
sales@tiedown.com
Online
Manual
Advertisement
Related Manuals for TIE DOWN Penetrator X3
Summary of Contents for TIE DOWN Penetrator X3
- Page 1 Serious injury or death may occur if this equipment is used for purposes other than intended. Tie Down Engineering provides the following instructions for the use and care of this equipment. It is the responsibility of the user to understand and convey proper instruction to any and all individuals who use this product for Fall Arrest and or Fall Restraint.
- Page 2 Mounting Frame Mounting Frame Tension Spring Retainer Tension Spring Retainer Spike Engagement Tube Spike Engagement Tube Penetrator Fall Arrest Spikes Connection Points Penetrator Fall Arrest Spikes TIE DOWN Safety Products Division Connection Points 800-241-1806 • 404-344-0000 • www.tiedown.com E1847, Rev. 9/24/21...
- Page 3 Note that a PFAS does NOT prevent a fall from occurring. The Penetrator X3 can be used as an anchorage in a PFAS for up to two workers. A Personal Fall Arrest System must meet the following OSHA requirements: •...
- Page 4 THE DECK CAN ACCOMMODATE THE LOAD REQUIREMENTS. Verify that the surface that the Penetrator X3 will be used on is capable of supporting both the unit and personnel using it. Inspect that the entire area to determine if the working surfaces have the strength and to support users safely.
-
Page 5: Range Of Use
Unprotected Edge or Leading Edge 30 Feet Maximum Safe Work Zone 15 ft. 45˚ 45˚ Cart Path After 15 feet the maximum Range of Use is 30 feet. TIE DOWN Safety Products Division 800-241-1806 • 404-344-0000 • www.tiedown.com E1847, Rev. 9/24/21... - Page 6 FALL ARREST TIE-OFF The three Fall Arrest Tie Off points are located on the lower side of the Penetrator X3 in bright red, under of the stay clear guard. The user must insure that the lanyards and harness are properly attached.
-
Page 7: Maintenance And Care
Look around and confirm a safe distance from the roof edge is being maintained. • The Penetrator X3 should not be used by persons whose ability or alertness is impaired by fatigue, intoxicating beverages, illegal or prescription drugs, or any other physical cause that exposes the user or others to injury. - Page 8 Hoisting Safety Precautions Loads may slip, if the Penetrator X3 is not hoisted properly, this could result in injury or death. Do not use with damaged slings or chains. Utilize appropriate rigging gear for overhead lifting. Utilize rigging gear within the industry standards and the manufacturer’s recommendations.
- Page 9 From the front of the PX3 insert the 3.5” carriage bolt through the roller bracket and PX3 frame. Attach 1/2” washer and nut. Use the impact wrench and tighten the nylock nut. TIE DOWN Safety Products Division 800-241-1806 • 404-344-0000 • www.tiedown.com E1847, Rev. 9/24/21...
- Page 10 WARNING - Be careful not to come in contact with the five penetrating spikes. TIE DOWN Safety Products Division 800-241-1806 • 404-344-0000 • www.tiedown.com E1847, Rev. 9/24/21...
- Page 11 Any rescuer must be tied off in a FRS before attempting to aid in a rescue. The number of rescuers allowed to tie off to the Penetrator X3 is 3 minus the number of fallen workers. Up to 2 (two) additional rescuers may tie off to the Penetrator X3 utilizing the two fall restraint tie-off shackles marked for FRS.
- Page 12 If the fallen worker is unconscious or unable to hook themselves up to the rescue cable additional rescue help will be needed. The additional worker must be tied off to the Penetrator X3. Using a rescue pole attach the hook/ cable to the fallen worker.
- Page 13 Procedure for Reseting the Penetrator X3 After a Fall Prior to disengaging the Penetrator X3 after deployment as the result of an fall incident, make certain that the rescue procedure has been successfully completed. The five penetrating spikes will be somewhat buried into the roof after activation.
-
Page 14: Declaration Of Conformity
DECLARATION NO. ETR-72810, 72841_R0 PART NUMBER(S): 72810, 72841 PART DESCRIPTION: Penetrator X3 Cart (PX3) ADDITIONAL INFORMATION REGARDING THIS DOCUMENT OR STANDARD(S) EVALUATED: • TIE DOWN ENGINEERING DECLARES THAT THE PRODUCT(S) LISTED ABOVE IS IN CONFORMITY WITH THE REQUIREMENTS OF THE FOLLOWING PERFORMANCE STANDARDS. - Page 15 TIE DOWN Safety Products Division 800-241-1806 • 404-344-0000 • www.tiedown.com E1847, Rev. 9/24/21...
- Page 16 Inspection Checklist and Maintenance Log Penetrator X3 Model #_____________________ Date of Purchase: __________________ Serial Number: ________________________ Purchased From: ______________________ Cart Date: Frame: Free of Rust? Frame: Welded Connections? Axles/Wheels Rotate Properly? Overall Cart Parts? Penetrator X3 Device Date: Frame: Free of Rust?
Need help?
Do you have a question about the Penetrator X3 and is the answer not in the manual?
Questions and answers