Table of Contents
Advertisement
Available languages
Available languages
Fig.4
► 1. Switch trigger 2. Lock button 3. Trigger-lock
button
To prevent the switch trigger from accidentally pulled,
the trigger-lock button is provided. To start the tool,
depress the trigger-lock button from A (
the switch trigger. Tool speed is increased by increas-
ing pressure on the switch trigger. Release the switch
trigger to stop. After use, depress the trigger-lock button
from B ( ) side.
For continuous operation, depress the lock button while
pulling the switch trigger, and then release the switch
trigger. To stop the tool, pull the switch trigger fully, then
release it.
Speed adjusting dial
The rotating speed can be changed by using the speed
adjusting dial on top of the switch handle. Turn the
speed adjusting dial to align the pointers with your
desired rotating speed indicated on the speed scale.
The rotating speed can be adjusted from 600 (RPM) to
2,200 (RPM), and a target speed can be obtained when
the switch trigger is fully squeezed.
2
3
Fig.5
► 1. Speed adjusting dial 2. Pointer 3. Speed scale
NOTICE:
If the tool is operated continuously
at low speeds for a long time, the motor will get
overloaded, resulting in tool malfunction.
NOTICE:
The speed adjusting dial turns between
600 and 2,200 on the speed scale. Avoid turning
the dial back and forwards further as it may cause
damage to the tool.
NOTE: Be sure to read numbers on the scale as an
indicator since the actual speed may fluctuate slightly.
3
2
1
) side and pull
1
Shaft lock
Press the shaft lock to prevent spindle rotation when
installing and removing accessories.
1
Fig.6
► 1. Shaft lock
NOTICE:
Never actuate the shaft lock while the
spindle is moving. The tool may be damaged.
Accidental restart preventive
function
If you install the battery cartridge while pulling the
switch trigger or locking the switch trigger, the tool does
not start. To start the tool, release the switch trigger, and
then pull the switch trigger.
Electronic function
The tool is equipped with the following electronic func-
tions for easy operation.
Constant speed control
Possible to get fine finish, because the rotating speed is
kept constant even under the loaded condition.
Soft start feature
The soft-start function minimizes start-up shock, and
makes the tool start smoothly.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing loop handle
CAUTION:
Be sure to hold the tool firmly with
both hands, positioning one hand on the switch
handle and the other on the loop handle, side grip
or tool head.
CAUTION:
Make sure that the loop handle is
installed securely before operation.
8 ENGLISH
Advertisement
Table of Contents
