tell CL5000 Series Installation Instructions And Template

INSTRUCTIONS AND TEMPLATE FOR
CL5000 SERIES PANIC KIT
ELECTRONIC LOCK
CL5000 Electonic Lock Trim
Using the template on page 2, install the CL5000 Lock Trim with the Exit Device. Tape
template to the door, mark the holes and drill where needed.
Battery Pack/
Cover
Top Fixing
Bolts
Thru-Bolts
(sold separately)
Installation Instruction
1. Tape template to the door and mark and drill holes where necessary.
2. Attach Fixing Trim Posts into the holes of front plate.
3. Attach lockset device to the door:
1st: Screw two Top Bolts thru Battery Bracket, thru door and into Lockset,
2nd: Attach Bottom Fixing Bolt into Fixing Post using Metal Flange when necessary.
4. Run battery wire terminal through the Wire Hole as indicated.
5. Attaching exit device to the door:
1st: Screw Top Fixing Bolts into top Fixing Posts
2nd: Attach bottom of exit with thru bolts (sold separately)
6. Fit the Spindle from the rear side spindle hole to the front plate.
7. Attach panic device to fixing posts, then at point insert fixing screws onto fixing post at point.
8. Plug in Battery Pack to the Lockset, place the wires into the door and attach Battery Pack to Bracket with Cover.
Tell Manufacturing | A Division of Spectrum Brands Inc.
Battery Bracket
Top Bolts
Metal
Flange
Bottom
Fixing Bolt
1
Wire Hole
Spindle
(marked
L or R)
READ AND FOLLOW
INSTRUCTIONS CAREFULLY.
Incorrect installation or adjustment
could cause damage or injury.
Lockset
Provided
Front Plate
Thru-Bolts
(sold separately)
C L
1-800-433-4047 | TEL035004-CL5000PK-110320
Fixing
Trim
Posts
C L