Fusion GMS4H User Manual page 20

CAREL® iJF PLATFORM PROGRAMMABLE CONTROLLER FOR HEATED CASES - PAGE 3 of 4
8. Screen Navigation - User Settings
 The figures below show how to navigate between screens on the display for USER SETTINGS only.
 Establishing USER SETTINGS are the MOST COMMON reason for needing to navigate the screen.
 CAREL acronyms: "USt" = User Settings / "CtL" = Control / "FSt" = Factory Settings / "ESC" = Escape / "dir" = Direct
Functions / "PSd" = Password.
 Note: These steps correspond with accompanying illustration.
A. Default setting will alternately display USt (User Settings) and its temp. setting (1.0 to 9.0). Note: Illustration shows "USt/5" to
convey that screen could be intermittently flashing "USt" and random number "5.0." To change the setting (and make case
either warmer or cooler), press the Program icon once. The "- - - " will appear (see next step).
B. Press Program icon again ("Ctl" appears; shown next step).
C. "Ctl" (Control) will now appear on the screen. Press Program icon again to get to "USt" (user setting; shown in next step).
D. Press Program icon again for current setting to be displayed (that you wish to change); the EXISTING setting (a sample setting
of "5.0 is shown at next step).
E. Sample setting of "5.0" is shown. Setpoint/Up and On-Off/Down arrow icon will be flashing. Change User Settings by pressing
the Setpoint/Up arrow
icon OR the On-Off/
Down arrow icon to
desired setting. Note:
You may adjust setting
from "1.0" (minimum
heat) to "9.0" (maximum
heat).
F. A sample "8"/"9"
setting is shown to
depict random settings
that may be chosen (for
illustrative purposes
only). After selecting
desired setting, press
the Program icon.
> Then press the
On-Off/Down key to
reach "ESC" (escape).
G. When at the "ESC"
screen, press the
Program icon again to
"lock in" the new
temperature settings.
H. The "---" image will
appear again with
several flashing icons at
lower left and right.
------- ------- ------- -------
> After approx. 5
seconds, the flashing icons
will stop and the new
flashing "USt/8" (or
whatever User Setting have
been selected) will
alternately appear on the
screen (as illustrated in
step "A" of these
instructions).
> User Settings have
now been selected and
locked.
------- ------- -------
> See next page for
Screen Navigation -
Factory Settings.
A
C
D
E
This data derived from CAREL® Programmable Controller Material +0300010EN -
rel. 1.0 - 10.05.2021 ||| User Manual/Carel_iJF Platform_Prog-Cont for Htd
Cases_User Manual_4-Pager ||| Rev A Date: 06/22/2022
20
B
H
G
F