Advertisement
2. INTRODUCTION
Adjustable telescopic pole for Model No's CP20VPSH Saw Head or CP20VPHT Hedge Trimmer Head. Lightweight and adjustable for easy
use with either choice of attachment. With adjustable clip waist fastener for added security.
3. SPECIFICATION
Model No: .............................................................. CP20VTP
4. OPERATION
IMPORTANT WARRANTY INFORMATION: the battery pack fitted to this cordless tool are considered to be a consumable item and
its ability to accept charge will reduce over time. We will provide warranty against mechanical and electrical defect for a period of
one year - this does not cover fair wear and tear. If the battery is not properly charged before first use, or regularly conditioned, its
capacity will diminish. Under these circumstances we will not replace the battery pack even if it is less than one year old.
4.1.
BATTERY INSTALLATION
4.1.1.
Hold the tool firmly and align the tongue on the battery cartridge with the groove in the housing and slide into place (fig 1).
4.1.2.
Fully push the battery cartridge until it locks into place with an audible click.
4.2.
BATTERY REMOVAL
4.2.1.
Hold the tool firmly and press the battery release button, then slide and remove the battery cartridge (fig 1).
fig.3
4.3.
BATTERY POWER INDICATOR
4.3.1.
Press the check button (fig 2), on the battery cartridge.
4.3.2.
The indicator lights (fig 2), will illuminate to indicate remaining capacity (fig 3).
4.4.
STARTING / STOPPING THE TOOL
4.4.1.
To start the tool, press the lock button (fig 4) in and pull the trigger switch (fig 4) upwards, towards the handle.
4.4.2.
To stop the tool, release the trigger switch (fig 4).
WARNING! Before attaching the battery cartridge to the tool, firstly check that the trigger switch returns to the OFF position when
‰
released.
WARNING! DO NOT use the tool if it can be started without pressing the lock button. Return the tool to an authorised Sealey
‰
service centre for repair.
DO NOT try and override the lock button by locking it down with tape or similar.
8
5. PROTECTION SYSTEM
The tool is equipped with a tool/battery protection system. This system automatically cuts off the power to the motor to extend the
tool and battery life. The tool will automatically stop during it's operation if the tool or battery is subjected to one of the following:
5.1.
OVERLOAD PROTECTION
5.1.1.
If the battery draws an abnormally high current, the tool will automatically stop, without and indication.
5.1.2.
Stop the operation that has caused the battery to become overloaded.
5.1.3.
Restart the tool.
5.2.
OVERHEAT PROTECTION
5.2.1.
If the tool or battery becomes overheated, the tool will automatically stop.
5.2.2.
Allow the battery or tool to fully cool down.
5.2.3.
Restart the tool.
5.3.
OVER DISCHARGE PROTECTION
5.3.1.
When the battery capacity becomes low the tool will automatically stop.
5.3.2.
Remove the battery cartridge from the tool.
5.3.3.
Recharge the battery cartridge.
© Jack Sealey Limited
fig.1
fig.4
Original Language Version
fig.2
CP20VTP Issue 1 25/10/21
Advertisement
