A-Tach Mounts ST-1 Instructions

A-Tach # 50135
Designed for: Kia Niro 2017 – 2019
For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed BEFORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
mount will attach into the two seams illustrated
with the arrows in the photo.
(3) Remove the covering from the tape. Align the
mount to fit the location between the start button
and radio volume button. Press the lower edge of
the mount into the seam next to the seam tool.
ST-1
NOTICE: A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
(2) Press the thin edge of the seam tool into the
seam between the panel around the radio and the
panel around the climate controls to open the
seam a little. See photo for location.
(4) Remove the seam tool from the lower seam
and insert it into the top seam to open the seam a
little. See photo.
A-Tach
Mounts