Panasonic KX-TCD715EM Service Manual page 68

Address Default
0F04 0F
0F05 15
0F06 28
0F07 3C
0F08 64
0F09 0A
Name
Cfg-1
Cfg-2
MakeTime
BreakTime
DtmfTime
InterDigitDtmfTime
Type
D PSTN line configuration 1 (factory
Bit
0: EarthBreakEnable , Earth break
0=disable
1:LoopBreakEnable, Loop break 1
=disable
2:PulseDialEnable, Pulse dial 1=enable
disable
3:RPauseEnable, usage of "R" pause
enable, 0=disable
4:PulseType,0=normal puls-type
1=('0'=1 pils,..'9'=10 puls's).
5: InterDigitLowImp. controls interdigit
impedance.
1: keep low-impedance during interdigit
pause
0: normal impedance during interdigit
pause
6: LowImpLineSeizure. Special low
seizure (Australian) , 1=enable , 0=
7: TwoLines. line config 0=one line,
lines Defaults to 0000 0111B.
PSTN line configuration 2 (factory
Bit
0: Meter-pulse, 1=enable, 0=disable
1: DialToneMode, dial tone detection
enable 0=disable
2: BusyToneMode. busy tone detection
enable 0=disable
3: CurrentLimiterMode, 1=enable,
4: RingToneMode. Ring tone detection
enable 0=disable
5: HookRelayEnable, 1=enable, 0=
(if same port is used for earth-control
EarthBreakEnable and HookRelayEnable
cannot both be set to 1).
6..7: not used
Defaults to 0001 0101B.
D Pulse make time.
Unit : 1 ms. defaults to 40 ms.
D Pulse break time
Unit : 1 ms, defaults to 60 ms.
D DTMF tone pulse time.
Unit : 1 ms, defaults to 100 ms.
D Inter-digit time in DTMF mode.
Unit : 10 ms , defaults to 100ms.
68
Description