General International 25-195N Quick Start Manual

STEEL SUPPORT STAND
FOR MAXI-LATHES
ASSEMBLY
1
1. Attach the middle and lower cross braces to one
leg using four carriage bolts with flat washers, lock
washers and nuts (two per cross brace) in the as-
sembly order shown.
2. Attach the second leg using the same hardware in
the same assembly order.
5
5. Repeat step 1 to 3 with the two other legs and cross
braces.
6. Attach the second leg/cross brace assembly using
four carriage bolts with flat washers, lock washers
and nuts as shown
25-195N_V2_12/01/2011
ITEM
#25-195N
2 3
3. Attach the upper top shelf using four carriage bolts
with flat washers, lock washers and nuts in the as-
sembly order shown.
4. Attach the two support trays using four carriage
bolts with flat washers, lock washers and nuts (two
per tray).
6 7
7 Take the 4 levelling feet and lock nuts supplied with
your lathe and attach them to the stand as shown.
www.general.ca
4