Lawn Mower Preparation - Power smart DB2194SH Instruction Manual

LAWN MOWER PREPARATION

The following section describes steps necessary to prepare the lawn mower for use. If after reading this section,
you are unsure about how to perform any of the steps please call (800) 791-9458 Mon-Fri 9-5 EST for customer
service. Failure to perform these steps properly can damage the lawn mower or shorten its lifespan.
UNPACKING
Tools required (not included): #2PH screwdriver, utility knife.
Unpack the lawn mower and all its parts, and compare against the list below. Do not discard the carton or any
packaging until the engine is completely assembled.
PACKING LIST
Side discharge chute*1
Grass Catcher*1
Cable clip*1
Spark plug wrench*1
Flange bolts M6*2
User manual*1
Funnel*1
2/5 inch Sleeve*1
1/2 inch*2/5 inch Wrench*1
ATTACH LOWER & UPPER HANDLE
1. Loosen two knobs and turn the folded upper tube to match the lower tube, and tighten the knob.
2. Turn the lower tube to an angle that matches the base and tighten with two screws. （ Two screws are in the
accessories bag. ）
3. Lock the cable to the lower handle using cable clip.
11