Polaris ACE 150 EFI 2019 Owner's Manual page 48

OPERATION
6. Turn the ignition key past the ON/RUN position to START. Engage the starter
for a maximum of five seconds. Release the key when the engine starts.
Operating the vehicle immediately after starting could cause engine damage.
Allow the engine to warm up for several minutes before operating the vehicle.
7. If the engine does not start within five seconds, return the ignition switch to
the OFF position and wait five seconds. Repeat steps 6 and 7 until the
engine starts.
8. Vary the engine RPM slightly with the throttle to aid in warm-up until the
engine idles smoothly.
9. Release the parking brake before driving.
STOPPING THE ENGINE
1. Release the throttle pedal completely and brake to a complete stop.
2. Place the transmission in NEUTRAL.
3. Set the parking brake.
4. Stop the engine.
BRAKING
1. Release the throttle pedal completely. (When the throttle pedal is released
completely and engine speed slows to near idle, the vehicle has no engine
braking.)
2. Press on the brake pedal evenly and firmly. Practice starting and stopping
(using the brakes) until you're familiar with the controls.
PARKING THE VEHICLE
1. Stop the vehicle on a level surface. When parking inside a garage or other
structure, be sure that the structure is well ventilated and that the vehicle is
not close to any source of flame or sparks, including any appliance with pilot
lights.
2. Place the transmission in NEUTRAL.
3. Set the parking brake.
4. Stop the engine.
5. Remove the ignition key to prevent unauthorized use.
46
Downloaded from ManualsNet.com
NOTICE
search engine