Tread Depth - Vauxhall Movano 2021 Owner's Manual

ESC has a malfunction or a
temporary spare wheel is used. Once
the road tyre has been refitted, check
the tyre pressure with cold tyres and
initialise the system.
Only mount wheels with pressure
sensors, otherwise the tyre pressure
will not be displayed and w
illuminates continuously.
A spare wheel or temporary spare
wheel is not equipped with pressure
sensors. The tyre pressure
monitoring system is not operational
for these tyres. Control indicator w
illuminates. For the further three
tyres, the system remains
operational.
The use of commercially-available
liquid tyre repair kits can impair the
function of the system. Factory-
approved repair kits can be used.
Operating electronic devices or being
close to facilities using similar wave
frequencies could disrupt the tyre
pressure monitoring system.
Each time the tyres are replaced, tyre
pressure monitoring system sensors
must be dismounted and serviced.
Auto learn function
After changing wheels or wheel
positions the vehicle must be
stationary for approx. 20 minutes,
before the system recalculates. The
following relearn process takes up to
10 minutes of driving in a speed range
of 25 to 60 mph. Avoid to drive outside
of this range for a longer time. If
possible, use a country road or similar
which allows continuous driving.
Ensure the tyre loading status is set
according to the selected pressure
3 60.
If problems occur during the relearn
process, a failure message is
displayed in the Driver Information
Centre. w will flash for 75 seconds
and then illuminates continuously.
If this happens, repeat learning
process. Keep your vehicle stationary
for approx. 20 minutes and then drive
again for 10 minutes as described
above.

Tread depth

Check tread depth at regular
intervals.
Vehicle care
For safety reasons, it is
recommended that the tread depth of
the tyres on one axle should not vary
by more than 2 mm.
The legally permissible minimum
tread depth (1.6 mm) has been
reached when the tread has worn
down as far as one of the tread wear
indicators (TWI). Their position is
indicated by markings on the
sidewall.
If there is more wear at the front than
the rear, swap round front wheels and
rear wheels periodically. Ensure that
the direction of rotation of the wheels
remains the same.
167