Table of Contents
Advertisement
attempt to re-ignite the burner for at least one
minute.
ATTENTION!
The burner may go out accidentally.
▶
If the burner's flame accidentally goes out, switch off
the burner's selector and wait at least one minute
before igniting the burner again.
The gas grill only works when the protective plate is in-
serted.
▶
Ensure that the protective plate has been inserted
correctly.
1.
Turn on the main gas supply to the appliance. Insert
the plug in the socket. Open the oven door.
2.
Insert the protective plate with the symbol facing up-
wards in such a way that the lugs lie completely in
the notches.
11 Time-setting options
Your appliance is equipped with a time-setting option
that can be used to set the timer.
11.1 Timer
The timer can be used as a kitchen timer.
The timer runs alongside other settings. The timer can
be set at any time, even if the appliance is switched off.
Note: The timer has no effect on how the oven works. It
can only be used as a kitchen timer.
12 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
12.1 Cleaning agent
To avoid damaging the different surfaces of the appli-
ance, do not use unsuitable cleaning agents.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
▶
Do not use steam- or high-pressure cleaners to
clean the appliance.
ATTENTION!
Unsuitable cleaning agents damage the surfaces of the
appliance.
▶
Do not use aggressive or abrasive cleaning agents.
Suitable cleaning agents
Only use cleaning agents that are suitable for the differ-
ent surfaces on your appliance.
There are three notches below the control panel. In-
sert the three lugs on the protective plate into the
three notches.
3.
Close the oven door so that it is as close as pos-
sible to the protective place.
4.
Push in the function selector and turn it clockwise to
the grill setting
.
5.
Keep the function selector pressed in and press the
ignition button at the same time.
Keep the function selector pushed in for 10
seconds so that the safety pilot starts up.
a The safety pilot is activated. If the gas flame goes
out, the gas supply is automatically shut off by the
safety pilot.
6.
Check whether the flame is burning.
If the flame is not burning, repeat the steps.
7.
Once the food is cooked, switch off the function se-
lector. Once the oven has cooled down, remove the
protective plate.
Setting the timer
The timer can be set up to 60 minutes regardless of
whether the appliance is on or off.
1.
Set the timer to the required cooking time.
2.
Once the timer duration has elapsed
An audible signal sounds. The timer automatic-
‒
ally switches to the Off position.
▶
Do not use cleaning products with a high alcohol
content.
▶
Do not use hard scouring pads or cleaning
sponges.
▶
Do not use any special cleaners if the appliance is
still warm.
Using oven cleaner in a hot cooking compartment
damages the enamel.
▶
Do not use oven cleaner in the cooking compart-
ment when it is still warm.
▶
Remove all food remnants from the cooking com-
partment and the appliance door before you next
heat up the appliance.
New sponge cloths contain residues from production.
▶
Wash new sponge cloths thoroughly before use.
Follow the instructions on cleaning the appliance.
→ "Cleaning the appliance", Page 19
Time-setting options en
17
Advertisement
Table of Contents
