Table of Contents
Advertisement
Table 9 Device Screen (continued)
L ABEL
Upgrade file
Browse
Note: The PLA will reset and the Web Configurator will refresh to the
successful installation. It is recommended that you compare the software version shown
on the Web Configurator's
installed, to confirm if the installation is successful.
3.7 Multic a st Se tting s
Multicast delivers IP packets to members defined by multicast groups. Membership to these multicast
groups are established using IGMP/MLD.
Internet Group Multicast Protocol (IGMP) is an IPv4 network-layer protocol used to establish membership
in a Multicast group – it is not used to carry user data.
Multicast Listener Discovery (MLD) is an IPv6 network-layer protocol that uses ICMPv6 message types,
rather than IGMP message types. MLDv1 is equivalent to IGMPv2 and MLDv2 is equivalent to IGMPv3.
Use the
Multic a st
Chapter 3 Web Configurator
DESC RIPT IO N
Type the location of the file you want to upload in this field or click
Note: Only use firmware for your PLA. Do NOT remove power from the PLA while
firmware upload is in progress!
Click this to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Click
to begin the upload process. This process may take up to 2 minutes. When the
O k
bar reaches
Do wnlo a d Pro g re ss
De vic e
screen to configure IGMP/MLD settings.
PLA6457 User's Guide
, click
100 %
Ha rdwa re Re se t
page
field with the firmware version
FW ve rsio n
25
to find it.
Bro wse
.
screen upon
L o g in
Advertisement
Table of Contents
