Table of Contents
Advertisement
Reference Notes
1. Locking Tabs (L-1) ,(L-2) are fragile. Be careful not
to break them.
1-1. Release five Locking Tabs (L-1).
1-2. Release three Locking Tabs (L-2) and
remove the PANEL FRONT.
2. The DVD MECHANISM & DVD/HDD MAIN
BOARD ASSEMBLY is adjusted as a unit at
factory. Therefore, do not disassemble it.
Replace the DVD MECHANISM & DVD/HDD
MAIN BOARD ASSEMBLY as a unit.
3. Whenever you have replaced the Hard Disk Drive,
initialize the Hard Disk Drive. To initialize the Hard
Disk Drive, perform the following.
3-1. To put the HDD & DVD Video Recorder into
the HDD mode, press the [HDD] button on
the remote control unit.
3-2. To put the HDD & DVD Video Recorder into
the self-check mode, after pressing
[VARIABLE SKIP] button, press the [0], [7],
and [9] buttons on the remote control unit in
that order within three seconds.
3-3. Press [ENTER/OK] button. The HDD & DVD
Video Recorder is initialized and the power is
turned off automatically after two seconds.
[1] COVER TOP
(S-1)
[5] PANEL FRONT
(S-1)
[7]
& DVD/HDD MAIN
BOARD ASSEMBLY
(S-5)
(S-1)
(S-1)
Fig. D1
[8] IEEE 1394
DV-IN CABLE
*
1-6-2
(L-1)
(L-1)
CN2204
(L-2)
[2] FRONT ASSEMBLY
[4] BOARD POWER SWITCH
(S-2B)
CN3001-F
*
DVD MECHANISM
(S-5)
CN901
(S-7)
DV PLATE EARTH
See Reference Notes 2.
(L-1)
Fig. D2
(S-2A)
(S-2A)
[3] BOARD
FRONT
Fig. D3
(S-4)
M-BOARD PLATE
EARTH
CN503
CN651
CN101
CN701
[6] HDD
ASSEMBLY
(S-3)
(S-3)
(S-6)
CN1015
BOARD SUPPORT
/ BOARD SPACERS
Fig. D4
E2J70DC
Advertisement
Table of Contents
