Yamaha R7 2022 Service Manual page 12

The fuel meter indicates the amount of fuel in the
fuel tank. The display segments of the fuel meter
disappear from "F" (full) towards "E" (empty) as
the fuel level decreases. When approximately
2.5 L (0.66 US gal, 0.55 Imp.gal) of fuel remains,
the last segment starts flashing. Refuel as soon
as possible.
TIP
If a problem is detected in the electrical circuit,
the fuel level segments will flash repeatedly. Re-
fer to "SIGNALING SYSTEM" on page 8-21.
Clock
1. Clock
The clock uses a 12-hour time system.
To set the clock
1. Turn the vehicle off.
2. While holding the "RES" switch, turn the vehi-
cle on. Continue holding the "RES" switch un-
til the hour digits start flashing.
3. Use the "SEL" switch to set the hours.
4. Push the "RES" switch and the minute digits
start flashing.
5. Use the "SEL" switch to set the minutes.
6. Push the "RES" switch to confirm the setting.
Transmission gear display
1
1. Transmission gear display
This display shows the selected gear. The neu-
tral position is indicated by "–" and by the neutral
indicator light.
Multi-function display
1. Multi-function display
The multi-function display is equipped with the
following:
• an odometer (ODO)
• two tripmeters (TRIP 1 and TRIP 2)
• a fuel reserve tripmeter (TRIP F)
• an instantaneous fuel consumption display
(km/L, L/100 km, or MPG)
• an average fuel consumption display (AVE_
_._ km/L, AVE_ _._ L/100 km, or AVE_ _ _._
MPG)
1
• a coolant temperature display (_ _ °C)
• an air temperature display (Air_ _ °C)
Push the "SEL" switch to change the display in
the following order:
ODO → TRIP 1 → TRIP 2 → TRIP F → km/L or
L/100 km or MPG → AVE_ _._ km/L or AVE_ _._
L/100 km or AVE_ _._ MPG → _ _ °C → Air_ _
°C → ODO
TIP
• The fuel reserve tripmeter appears only when
you are low on fuel.
• Use the "RES" switch to change the display in
the reverse order.
Odometer
The odometer shows the total distance traveled
by the vehicle.
TIP
The odometer will lock at 999999 and cannot be
reset.
Tripmeters
The tripmeters show the distance traveled since
they were last reset.
To reset a tripmeter, change the display to the
tripmeter you want to reset, and then hold the
"RES" switch until it is reset.
1-3
FEATURES
1