Table Of Contents - Siemens Water Technologies Series Manual

INTRODUCTION

Table Of Contents

WT.050.130.000.UA.IM.1108
ACUTEC™ 35 SYSTEM
The Siemens Water Technologies Series 50-130 Acutec™ 35 Gas Detec-
tion system is an on-line monitoring system for the detection of chlorine
(Cl ), sulfur dioxide (SO
2
contacts are provided to transfer at user selectable setpoints. Monitor
modules provide a digital readout of gas level and a 4-20 mA output.
Single or Dual Units are available, using any combination of gas detec-
tors and monitors or alarm units.
One Receiver Module is connected to each gas Sensor/Transmitter with a
two-conductor cable, and provides information on the gas concentration
in the sensor area. Receivers are powered by the Power Supply Module
supplied with the Gas Detector system.
The Series 50-130 Sensor/Transmitter consists of an electrochemical gas
sensor and an electronic amplifier that transmits a gas concentration
signal to a Receiver Module located in the Control Unit. An optional gas
generator may be ordered which enables the Receiver to automatically
test the sensor every 24 hours.
NOTE: When ordering material always specify model and serial num-
ber of apparatus.
Very Important Safety Precautions .......................... SP-1,-2
Regional Offices ..................................................... 1.010-1
Technical Data ........................................................ Section 1
Installation ............................................................. Section 2
Operation ............................................................... Section 3
Service ................................................................... Section 4
Parts Illustrations .................................................... Section 5
Spare Parts List ....................................................... Section 6
Introd.
), or ammonia (NH ) gas in ambient air. Alarm
2 3