Homelegance 1743-5 Assembly Instruction

Dresser / commode

Thank you for purchasing this product. Please take time to read and follow the instructions below. Check that you have all parts and

hardware before assembly. Parts apparently missing are often found in the packing materials. If you do not have all the parts listed,

have your dealer contact us and they will be sent to you immediately.

It is recommended to install protective pads under all legs and support to avoid damage or

scratches when placing furniture on a wood floor or other hard surface, and to limit

indentation and prevent discoloration if placing on carpet.

Il est recommandé de placer des coussins protecteurs sous tous les pieds et toutes les

bases des meubles pour éviter d'endommager ou d'égratigner les planchers en bois ou

autres surfaces dures, et pour limiter l'empreinte et empêcher la décoloration quand les

meubles reposent sur la moquette.

This anti-tipping kit must be attached to a wall using the provided long screws.

Cette trousse anti-basculement doit être fix

ASSEMBLY INSTRUCTION/

INSTRUCTIONS D'ASSEMBLAGE

1743-5

DRESSER / COMMODE

sur un mur à l'aide des vis longues fournies.

PARTS LIST / LISTE DE PIECES

DRESSER / COMMODE

PAGE 1 OF 1

Table of Contents

Need help?

Do you have a question about the 1743-5 and is the answer not in the manual?

Page 1 ASSEMBLY INSTRUCTION/ INSTRUCTIONS D'ASSEMBLAGE 1743-5 DRESSER / COMMODE Thank you for purchasing this product. Please take time to read and follow the instructions below. Check that you have all parts and hardware before assembly. Parts apparently missing are often found in the packing materials. If you do not have all the parts listed, have your dealer contact us and they will be sent to you immediately.
Page 2 ASSEMBLY INSTRUCTION/ INSTRUCTIONS D'ASSEMBLAGE 1743-5 DRESSER / COMMODE Thank you for purchasing this product. Please take time to read and follow the instructions below. Check that you have all parts and hardware before assembly. Parts apparently missing are often found in the packing materials. If you do not have all the parts listed, have your dealer contact us and they will be sent to you immediately.
Page 3 ASSEMBLY INSTRUCTION/ INSTRUCTIONS D'ASSEMBLAGE 1743-5 DRESSER / COMMODE Step 3 : Place the dresser into position so both mounting bracket (4) are vertically in line. Lace the end of the restraint strap through the bigger hole on each bracket. Bring both ends together and slide the flat end through the locking end and draw it through until all slack is removed. Please make sure that the strap is securely laced and locked.