Advertisement
OPERATING INSTRUCTIONS
Place pump on horizontal surface or hang it by means of the hook.
Open mattress on the bed. Secure it with end flaps or straps. Air tubes must be at foot end of bed.
Connect air feed tubes to air outlet on the mattress and pump, ensuring that the tubes are
not kinked or twisted. Allow space for bed rails to drop freely.
Turn on the pump power. The indicator of the power switch will come on. The pump starts to
pump air into the mattress.
The Low Pressure Indicator (orange) will come on as inflation initiates.
When the pressure reaches the preset level within approximately 30 minutes, the Normal
Pressure indicator will come on, and the Low Pressure Indicator will turn off.
Turn the Pressure Adjust Knob to set a comfortable pressure level from soft to firm.
ENVIRONMENT REQUIREMENTS
Operation Temperature: 50
Storage Temperature: 5
Operation Humidity: 20%~80% non-condensing
Storage Humidity: 10%~90% non-condensing
CLEANING GUIDELINES
Can be cleaned by disinfectant solution
Do not immerse the pump in water
Do not heat or steam in autoclave
The mattress and cover are aerated until they are fully dry
TECHNICAL SPECIFICATIONS
Pump
Item: Protekt 1
ST
Power supply: 120V/60Hz, 1A
Air output: 8 Liter/min.
Pressure range: 30mmHg-60mmHg
Cycle time: 10 min.
Power consumption: 9W
Normal/Low pressure light
Static mode
Size: 10.6"(L)x6"(W)x4"(H)
Weight: 3.5 Lbs
F~95
F (10
o
o
F~122
F (-15
o
o
(When cleaning the inside of the mattress, remove foam insert).
Defense
C~35
C)
o
o
C~50
C)
o
o
Item: Protekt 1
Size: 80"(L)x36"(W)x7"(H)
Top cover: Nylon/PU with zipper
Air cells: Nylon/PVC
Base: Nylon/PVC
16 air cells
CPR valve for emergency procedures
Pillow function
Quick connectors
With low air loss
2
Mattress
Defense
ST
Advertisement
